User's Manual

This device complies with Part 15 of the Federal
Communications Commission Rules (47 C.F.R. Part 15).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must
accept any interference received, including interference
that may cause undesired operation.
That the product is manufactured at a facility registered
with the Food and Drug Administration.
TABLE OF CONTENTS
• Warnings
• Labels
• Know your SPRYNG™ device
• Operating Instructions
• Know The Led Indications
• Caring for Your SPRYNG™
• Technical Information
• Troubleshooting
WARNINGS
IMPORTANT SAFETY INSTRUCTIONS: Read the entire
instruction manual before using the SPRYNG™ devices.
These warnings apply to the appliance and, where
applicable, to all accessories.
WARNING: Keep away from water. As with most electrical
appliances, electrical parts in this product are electrically
live even when the switch is off.
1.To reduce the risk of electric shock, do not use the
product near or place in water.
2.Do not place or store where it can fall into a bathtub, sink,
or washing machine.
WARNING! If you experience severe pain, any unusual
symptoms or want to remove excessive pressure during
use:
1.Stop the device by pressing the Power Button.
2.Remove the SPRYNG™ device(s) from your limb(s).
3.Promptly consult your licensed healthcare practitioner.
Do not attempt to take apart the system. If repairs are
required, it must be done by the manufacturer. Please
contact customer service at [e-mail] for
more information. Do not use the product if it is damaged
or requires repairs.
Use the product only as recommended and with the
charger and power cord provided. The use of other
chargers and power chords may harm the operation of
the system.
Do not place the system, charger, charging cable, or any
accessories where they could present a fall hazard. 󰿉
Keep the USB charging ports of the SPRYNG™ system
free of debris.
Do not puncture or otherwise damage the inflatable parts
of the SPRYNG™ device. The system should not be used
if damaged in any way.
DO NOT USE this product if you are experiencing
inflammation, an infection, pain of unknown origin,
bleeding (internal or external) at or near the site of
application, or if you have a wound at or near the site of
application.
DO NOT USE this product if your doctor advices against
the use of Spryng.
If you have any existing medical condition consult your
doctor before using Spryng.
DO NOT USE this poduct if you are allergic to any of the
materials, and it should be used only on
intact/undamaged skin.
DO NOT USE this product if you have any of the following
conditions:
• Acute pulmonary edema
• Acute thrombophlebitis
• Acute congestive cardiac failure
• Acute infections
• Deep vein thrombosis (DVT)
• Episodes of pulmonary embolism
• Wounds, lesions, or tumors at or near the site of application
• Where increased venous and lymphatic return is
considered unsafe
• Bone fractures or dislocations at or near the site of
application
• Skeleton injuries and diseases
• Bone fractures in area of usage
• Currently being treated for Cancer
• High/abnormal blood pressure
• Severe atherosclerosis or other cardiac diseases
• Congestive heart failure
• Gangrene, untreated or infected wounds, recent skin
graft, and dermatitis in the legs
• Known presence of malignancy in the legs
• Active limb infections, including cellulitis
• Presence of Lymphangiosarcoma
Do not use this product:
• During pregnancy or for at least six months after giving
birth
• If you have an implantable device such as a cardiac
pacemaker
Children should not use this product. Do not use on anyone
who is unconscious or incapacitated as this may present an
increased risk of harm.
Each SPRYNG™ unit contains a rechargeable Lithium-ion
Battery. It should be disposed inaccordance with any
applicable local regulations.
It should be disposed with the unit once the battery fails to
hold a charge.
LABELS
The following labels and symbols appear on the SPRYNG™
recovery wrap and removable innerLayer.
KNOW YOUR SPRYNG™ DEVICE
CHARGING INSTRUCTIONS
1.To charge your SPRYNG™ device, plug the included USB
charging cable into the AC/DC power adaptor, and then
plug the adaptor into a power outlet.
2.Depending on the charge level of the battery, its capacity
and the power level drawn while being charged, the device
would typically take up to 2.5 hours to charge fully.
3.When charging, 2 bars of red LEDs will pulse. When the
charging is complete, 2 bars of green LEDs will light up in
full brightness.
4.When the battery level is at 20% capacity or below, the
LEDs will show a yellow light and fade out repeatedly.
OPERATING INSTRUCTIONS
1.Once the device is fully charged, wrap one SPRYNG™
sleeve around each leg.
2.Long press (3 seconds) on the “Power” button (middle)
once for your SPRYNG™ device to turn the device on.
If using both the right and left sleeves, then you would have
to turn on both the devices separately. The devices will
start therapy by default in Mode 1, Intensity 1.
3.To adjust the compression patters, Short press
(1/2 second) on the “Mode” button (Left).
4.To adjust the compression intensity, Short press on the
“Intensity” button (Right). The three compression intensities
are low, medium, and high.
5.A therapy session lasts up to 15 minutes and the device
will shut off automatically after each therapy.
6.Should you experience pain or discomfort they should
shut it off immediately by long pressing the “Power” Button
7.To pause, Short press the Power button.
8.To shut-off the device, simply Long press the Power button.
9.When not in use turn off the power.
10.Store the SPRYNG™ device either in the original
packaging and/or in a cool and dry place.
Adjusting the Compression Level and Pattern
• Short Press on the Mode button (Left) sequentially to
select Mode 1: Graduated Pattern or Mode 2: Pulsing Pattern.
• Short Press on the Intensity button (Right) sequentially to
select low, medium or high intensity level.
Bonus Feature!
You can control the left device using the right device.
1.Once both devices are switched on, align each leg such
that the inner sides of the right and left devices are aligned.
2.Press any button (Power On/Pause, Mode, Intensity) on
the right device to control the left device.
CARING FOR YOUR SPRYNGTM
Cleaning your SPRYNG™
To clean the SPRYNG™ calf wrap, wipe down with a damp
clean cloth and dry with a fresh clean cloth. To clean the inner
washable layer, detach from Velcro tabs and wash at
30° C/86° F.
Do not use bleach.
Do not tumble dry.
Storing your SPRYNG™
Store the SPRYNG™ calf wrap in a clean and dry location.
Additional accessories and replacement parts
Please contact customer services using [e-mail]
for information regarding the SPRYNGTM wrap and
attachments.
TECHNICAL INFORMATION
• Do not attempt to take apart the system.
• The system has no user-serviceable parts.
• There are no user-replaceable fuses.
WARRANTY INFORMATION
SPRYNG™ LIMITED 6 MONTHS WARRANTY
SPRYNG™ ATTACHMENTS AND OTHER ACCESSORIES
LIMITED 6 MONTH WARRANTY
The SPRYNG™, as well as its attachments and accessories,
are warranted by MAS Design Inc, a New York corporation,
against manufacturing defects in material and workmanship
for a period of 6 months from the date of purchase from
SPRYNG™. In the event of any such defect occurring during
the warranty period, SPRYNG™ will, at its option, (a) correct
the defect by repair or by replacement of the applicable part
or component that fails because of such defect, without
charge for parts and labor; or (b) replace the device with one
of the same or then current design.
The foregoing Warranties do not cover normal wear and tear
or cosmetic damage, and are void if the device and/or other
attachments (collectively, the “product”) are not used,
maintained, or stored in accordance with the User Manual,
are otherwise misused or modified in any way, and/or are
repaired or altered by anyone other than an authorized
service representative of SPRYNG™. The Warranties will
also become void if the user tampers with the product
(e.g., opening the zipper of the inner section, breaking the
seal on the controller, removing the air tubes from the air
bag or the controller unit. These Warranties expressly
exclude transportation, shipping or insurance costs, or
defects, damages or failure resulting from misuse, abuse,
improper or abnormal usage, or neglect.
PRODUCT OR ARISING OUT OF THE USE, INABILITY TO
USE OR ANY BREACH OF THESE WARRANTIES,
INCLUDING BUT NOT LIMITED TO ANY DAMAGES
RESULTING FROM INCONVENIENCE, LOSS OF TIME,
PROPERTY OR INCOME, OR ANY INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY
KIND.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation
or exclusion may not apply to you. These Warranties give
you special legal rights, and you may also have other rights,
which vary from state to state.
All replaced parts and products become the property of
SPRYNG™ c/o MAS Design Inc., NY. New or reconditioned
parts and products may be used in the performance of
Warranty service. Repaired or replaced parts and products
are warranted for the remainder of the original warranty
period only. You will be charged for repair or replacement
of parts and products made after the expiration of the ap
plicable Warranty period.
TROUBLESHOOTINGE
Problem Possible CausesSolutions
Long Press the Power
Button to turn the unit
Plug in the SPRYNG™
device to AC/DC adapter
to charge the battery
and turn on device once
the device is charged
Contact SPRYNG™
Customer Service at
[e-mail]
The system
does
not start
Power is not
turned on
Low Battery
The device has
been damaged
The device
does not
inflate and
provide
compression
The session has
not been started
The session has
ended.
The device is
paused.
The device has
been damaged
Wait a few seconds and
the device will start
compressing
Long Press the Power
Button to turn the unit on
Short Press the Power
Button to resume
Contact SPRYNG
Customer Service at
[e-mail]
The Right
device pair
does not
control the
Left device
The Infared
receiver and
transmitter are
not aligned in line
of sight
Align the left and right
devices so that the
Infared receiver and
transmitter ports in line
of sight and then press
the required button on
the right device.
ERROR-
Yellow Light
Flashes
Low Battery
Indication and
the device will
stop working
soon
Plug in the SPRYNG™
device to AC/DC adapter
to charge the battery.
Contact SpryngTM Customer Service at
[e-mail] if further assistance is needed.
1
2 3 4
5 86 97
10
Internal Battery Information
• This device contains a rechargeable Lithium-ion battery.
• The battery will provide power for up to 2.5 hours of
continuous use.
• The SPRYNGTM product CANNOT be used while being
charged by a AC/DC adapter.
• It takes approximately 2.5 hours to fully charge the battery.
• The rechargeable Lithium-ion battery is intended to be
changed only by service personnel with the use of a special
service tool.
Electrical Details
• Spryng™ Per Unit Electrical Requirement:
5V DC 1.0A AC-DC Adapter
WARNING!
Use only the AC-DC Adapter provided with the system.
Using a different adapter may cause the system to not
operate correctly.
• Input: 100-240v 0.5 A 50/60 Hz
• Output: 5v Dc 2.0 A
• Charging Port: Micro-USB
Operating & Storage Conditions
Temperature (Operating): +41° F To 104° F [+5° C To +40° C]
Temperature (Storage): 50° F To +86° F [10° C To +30° C]
Relative Humidity (Operating): 15% To 93%, Non-Condensing
Relative Humidity (Storage): +10°C (+50°F) Without Relative
Humidity Control; +30°C (+86°F) at Relative Humidity Up To
93%, Non-Condensing
Therapy duration: 15 minutes
Total Usage Time From One Charge: 2.5 hours
Charge Time: 2.5 hours
Compression Intensities: 3 levels
Compression Patterns: 2 sequences
Charging Port: Micro-USB
EXCEPT AS PROVIDED ABOVE, SPRYNG™ MAKES NO
EXPRESS WARRANTIES OR ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE OR USE, AND ARE
LIMITED IN DURATION AS STATED ABOVE. EXCEPT AS
EXPRESSLY STATED ABOVE, SPRYNG™ SHALL HAVE NO
LIABILITY OR RESPONSIBILITY TO ITS CUSTOMER,
OR ANY OTHER PERSON OR ENTITY, WITH RESPECT
TO ANY LIABILITY, LOSS OR DAMAGE CAUSED
DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE
OF THE
Charging Port – This is used to recharge your Spryng
device using a USB charging cable
Velcros – These are used to fasten your Spryng devices
once wrapped around your legs
IR Port – These are for the Infra-Red emitter and receiver
Button – These are used to interact with the device, power
on/off, to change modes and increase/decrease level of
intensity
Hard Module Section – This contains the electronics of the
device. It is meant to sit on your shin when using Spryng
Inflating Section – This contains an air
bag which provides compression. This is meant to wrap
around your leg when using
SpryngLED – Will provide light indication when using Spryng
NOTE 1: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
that to which the receiver is connected.