USER MANUAL powered by spot functionality GPS security system 1 0 0 % s a t e lli t e t e ch n olog y
SPOT HUG USER MANUAL Table of Contents 2 Welcome ..............................................................3 Key Terminology ...................................................4 How HUG works ...................................................5 Getting Started ...................................................6 Initial System Setup/Test ...................................12 Installation of Tracker and Keypad ....................15 Using SPOT HUG ...............................................
WELCOME SPO T H U G U SER MANUAL SPOT HUG is a low-cost, easy to install satellite-based GPS asset monitoring, security and messaging system. It provides the asset owner with peace of mind when they are away from their asset via state-of-the-art asset tracking and sensor monitoring functionalities. When on the boat and in range of the Tracker, HUG also provides the owner with the ability to send messages and request help in an emergency.
Key Terminology SPO T H U G U SER MANUAL Unauthorized Movement If the asset moves more than 500 meters without the user’s authority and the key FOB is not present, unauthorized movement is detected and an alert is sent to a third party Asset Monitoring Center.
How SPOT HUG Works SPO T H U G U SER MANUAL 5 SPOT SATELLITE Technology Unauthorized Movement 1. GPS satellites provide signals. 2. SPOT HUG Tracker’s onboard GPS chip determines the asset’s GPS location and sends the location information to communication satellites. 3. Communication satellites relay your message to specific satellite antennas around the world. 4. Satellite antennas and a global network route your location and message to the appropriate network. 5.
Getting Started SPO T H U G U SER MANUAL Please read through the user guide to familiarize yourself with the SPOT HUG contents, system set-up and usage. HUG can be installed by the individual user or by a qualified marine electronics installer. Service activation is required to begin using any of the HUG features. Visit findmeSPOT.com to activate or follow the procedures in the Service Activation section within this user guide.
Getting Started SPO T H U G U SER MANUAL component overview A TRACKER A Tracker Mounting Bracket B Tracker LEDs C SOS Button D This Side Up Logo E Line Power/Sensor Alert Port B c d e 7
Getting Started SPO T H U G U SER MANUAL component overview key fob A key fob battery status led B gps led C tracker range led D track progress button/led E sos led f sos button g help button h help led i check-in/ok button/led b A c i d h e g f 8
Getting Started SPO T H U G U SER MANUAL component overview a keypad A 1-0: 10 alpha numeric keys B gps led C tracker battery power led D message sending led E tracking button/led f sos led g sos button h help button i help led j check-in/ok button/led k kaypad battery power led l tracker range led b l c k d j e i f h g 9
Getting Started SPO T H U G U SER MANUAL 10 Installing the batteries Installing the batteries on the Key FOB • Access the battery compartment by removing the 4 screws on the back plate of the FOB. Insert coin cell battery. • Replace FOB cover and screw tightly for secure waterproofness. • Repeat for second FOB. Installing the batteries on the Keypad • Remove Keypad back plate cover using a small screwdriver to loosen the six screws. • Insert the coin cell batteries into the Keypad.
Getting Started SPO T H U G U SER MANUAL 11 Keeping Your Contacts in Touch ADDITIONAL SERVICES Up to 10 contacts can be added for receipt of your Check-in/OK, and Help messages, and you can update these at any time on the website by logging in to your account. You can specify any combination of text/SMS messages or email for the contacts. At findmeSPOT.com you can also purchase additional service options either at activation or anytime you go back to the site.
Initial System Setup/Test SPO T H U G U SER MANUAL 12 Tracker System Setup Before installing the Tracker and mounting the Keypad in their permanent locations, it is necessary to ensure all components are working properly. You must have activated your SPOT HUG account to perform the system setup/test. The Tracker comes from the factory paired with the Keypad and 2 Key FOBs. 1. Set up all three units (Tracker, Keypad, and FOB) together in a clear line of sight to the sky.
Initial System Setup/Test SPO T H U G U SER MANUAL 13 Keypad System Setup System Test and Setting PIN After installing the coin size Lithium batteries, the Keypad will perform a self-test. The self test checks for battery level, and the presence of the Tracker and Key FOB. When the presence of the FOB and Tracker are confirmed, the Keypad then performs a system check to identify if it is correctly paired to the Tracker. 1. The Keypad will check for presence of the Tracker.
Initial System Setup/Test SPO T H U G U SER MANUAL 14 Key FOB System Setup Send a Test Check-in/OK Message The Key FOB device system test is similar to the Keypad. SPOT HUG recommends testing the Check-in/OK during the initial system set-up, on occasion and before every trip to ensure messages are sent and delivered properly. Before sending your first Check-in/OK message, synchronization of the Keypad and Key FOB devices with the Tracker are required.
Installation SPO T H U G U SER MANUAL 15 /////////////////////////////////////////////////////////// SOS Installation of Tracker Fiberglass /////////////////////////////////////////////////////////// SOS Once all three units are operational and provisioned after verifying the Check-in/OK messages have been delivered correctly, they can be placed in their desired permanent locations. For permanent installations, ensure the appropriate connectors (screws…etc.
Installation SPO T H U G U SER MANUAL 16 Installation of Tracker with Sensor Alerts Each SPOT HUG Tracker comes with four (4) Sensor Alert inputs. These Sensor Alert wires can be attached to sensor devices in order to monitor high water, battery level, door opening/closing, and other equipment that the user chooses. Sensor devices are not included with HUG but are available as accessories at marine electronics dealers and findmeSPOT.com.
Installation SPO T H U G U SER MANUAL 17 Installation of Keypad The Keypad is the device required to activate the Key FOB during the initial setup phase. For security, the user is required to change the factory default PIN before use (A step covered previously in the Keypad System/Test section). ‡ 1. Locate a place where the Keypad can be mounted inside the cabin. The Keypad needs to be within 60 feet/18 meters of the Tracker.
Using SPOT HUG SPO T H U G U SER MANUAL 18 SPOT HUG Alert Notifications Sensor Alert Notifications Arming and Disarming HUG for Unauthorized Movement THE SPOT HUG will be automatically armed once the Key FOB has left the Tracker range (60 ft/18m). HUG will be automatically disarmed and remain disarmed when a paired FOB comes into and stays within Tracker range. The Tracker frequently checks for the presence of the paired FOB to ensure security.
Using SPOT HUG SPO T H U G U SER MANUAL 19 Daily Status Message types of messages activated by user (fob and keypad) A daily status notification message is sent to the user and selected recipients based on the user profile on findmeSPOT.com. function - Alert emergency responders to your GPS location.
Using SPOT HUG SOS (FOB/Keypad/Tracker) NOTE: To be used in emergency situations. You may be liable for the cost of your rescue. For life-threatening or other critical situations, alert the GEOS International Emergency Rescue Coordination Center (IERCC).
Using SPOT HUG SPO T H U G U SER MANUAL 21 Check-in/OK (FOB/Keypad) Let your contacts know where you are and how you’re doing; or mark a single waypoint to review later. Your contacts will receive SMS/text or email messages with your GPS coordinates. Email messages also include a link to view your location using Google MapsTM.
Using SPOT HUG SPO T H U G U SER MANUAL 22 Track Progress Send your location to allow contacts to track your progress in near realtime using Google Maps™ or SPOT Adventures, giving them a virtual breadcrumb trail of your remote travel. Also automatically mark your waypoints to review later. Your contacts can see your progress on the web links that you create in your SPOT HUG account. Additional service fees may apply. See account information at findmeSPOT.com to learn more.
How the LEDs Blink SPO T H U G U SER MANUAL By Function for Tracker, key FOB/Keypad LED LED Activity Green When connected to line power Solid When using batteries only Blinking If GPS or satellite transmitter self-test fail If battery power is low GPS GPS fix Blinking No GPS fix If GPS or satellite transmitter self-test fail SOS When SOS is sent Blinking If GPS or satellite transmitter self-test fail Red Power Power/GPS/
How the LEDs Blink SPO T H U G U SER MANUAL 24 If Tracker doesn’t find your GPS location. It is important to test the Tracker unit before permanent installation. Function Function button LED GPS LED Messages Sending LED (Keypad only) Message Status to try again SOS Blinks Green Blinks Red. Tracker looks for GPS for 4 minutes then rests for 1 minute. Blinks Green Message Sent without GPS Move the vessel to an area with a clearer view of the sky.
How the LEDs Blink SPO T H U G U SER MANUAL By Status for key FOB, Keypad and Tracker STATUS LED Green Red Tracker Range Fob/Keypad TR LED blinks green if FOB is within 60 ft Fob/Keypad TR LED Blinks red when out of range Tracker Power Status (ON/OFF on the Tracker) Solid green when it is line powered; Slow blink green when battery powered. Blinks red when batteries are running low. Tracker Power Status (Battery icon on Keypad) Blinks red when batteries are running low.
Keypad Functions SPO T H U G U SER MANUAL The Keypad can be used to manually arm/disarm SPOT HUG. It is also used to turn on/off the GPS information in the daily status message, change PIN, pair additional Key FOBs and to enable/disable sensor alerts. Finally it can also be used to initiate and cancel SPOT modes.
Care and Support SPO T H U G U SER MANUAL 27 Battery Life and usage for Tracker, Keypad and key FOB • Use only non-rechargeable AA Lithium batteries in your Tracker as a backup to line power. If using the Tracker with batteries only, follow guidelines in this section. We highly recommend EnergizerTM Ultimate 8x AA Lithium batteries (L91). Alkaline or other battery technologies, including rechargeable varieties, are not recommended.
Care and Support SPO T H U G U SER MANUAL 28 OPERATING CONDITIONS AND CLIMATE SMS information For safety, keep the following in mind regarding the care and usage of each of the three HUG components: Additional charges may apply in some regions. Standard text messaging charges from your mobile phone provider may also apply. Tracker • 12/24 VDC line power input.
Care and Support SPO T H U G U SER MANUAL 29 LIMITED WARRANTY FCC/IC NOTICE Spot LLC warrants that your SPOT HUG will be free from defects in materials and workmanship under normal use for a period of 12 months (24 months for European customers) from the date of original purchase from Spot LLC or an authorized reseller with receipt. For full details regarding the Limited Warranty and warranty claim procedures, visit findmeSPOT.com.
