User's Manual

ManualsBrandsSpin Master Toys Far East ManualsElectronicsRC Kite

Please read all warnings

and instructions completely

before assembling

and operating this toy.

Keep this instruction

manual for future reference.

BATTERIES REQUIRED (not included)

2 x AAA alkaline batteries for the kite

1 x 9 volt alkaline battery for the remote

LINE WINDER REMOTE

KITE

Carefully unpack

all contents and

identify the parts

and features shown.

CONTENTS:

1. Kite

2. Line Winder Remote

3. Steering Servo

4. Horizontal Rod

5. Tail Ribbon

WARNING: Do not fly this toy near tall buildings, trees, or other objects that may cause the toy to

become entangled. Do not operate this toy in high winds, thunderstorms, or wet weather! Do not fly

near airports. Do not fly near overhead power lines. NEVER try to retrieve the kite from power lines

or a power pole. Call your local power company for help. Do not fly over people or pets.

IMPORTANT BATTERY INFORMATION:

Batteries should be installed by an adult.

Ensure battery polarity is correct (”+” positive & negative “-” orientaion).

New alkaline batteries are recommended for best performance.

Do not mix old and new batteries.

Do not mix alkaline, standard, rechargeable or different types of batteries.

Always turn Wind Chaser™ off before installing or removing batteries.

Battery compartment may be hot after use – allow to cool before handling.

Remove used up batteries.

Remove batteries from kite & remote when not in use or when storing kite.

Battery life may vary depending on battery brand.

Do not dispose of batteries in fire as batteries may explode or leak.

Do not recharge non-rechargeable batteries.

Do not short-circuit terminals.

Dispose of batteries safely.

ADULT SUPERVISION IS STRONGLY RECOMMENDED WHEN OPERATING THIS TOY

Page 1

INSTRUCTION

MANUAL

Radio Control

Stunt Switch

Spool

Lock Lever

Sliding

Battery

Door

1 x 9 volt alkaline

battery required

Flexible Antenna

Spool Tension Trigger

String

Connector

Spool

Crank Handle

Steering Servo

Attachment

to Keel

Steering Servo

String from

Line Winder

Remote

Tail

Ribbon

Antenna Wire

(do not cut)

Soft Foam Nose

Kite

Keel

Summary of content (6 pages)

PAGE 1
® TM INSTRUCTION MANUAL ADULT SUPERVISION IS STRONGLY RECOMMENDED WHEN OPERATING THIS TOY WARNING: Do not fly this toy near tall buildings, trees, or other objects that may cause the toy to become entangled. Do not operate this toy in high winds, thunderstorms, or wet weather! Do not fly near airports. Do not fly near overhead power lines. NEVER try to retrieve the kite from power lines or a power pole. Call your local power company for help. Do not fly over people or pets.
PAGE 2
HOW TO INSTALL THE 9 VOLT BATTERY IN THE REMOTE OPTIONAL LEFT HANDED CONVERSION 1. Start with a new 9 volt alkaline battery. 2. Push & slide battery door open. 3. Insert battery following the polarity (+) & (-) orientation shown in the drawing. 4. Close battery door & slide to lock in place. Battery Door New 9 volt alkaline battery Side Rod Left-handed cranking is possible by switching the cranking handle to the opposite side of the remote (remove two screws as shown).
PAGE 3
Line Winder Remote HOW TO INSTALL BATTERIES IN STEERING SERVO Steering Servo Battery Door Latch KITE ASSEMBLY (continued) Figure 5 UNLOCK Spool Lock Lever In case the Steering Servo needs to be repaired or replaced: Squeeze Locking Tab to slide Steering Servo up and off the Keel as shown. Kite String Connection to Steering Servo 1. Squeeze Latch to open Battery Door at bottom of Steering Servo. 2. Insert 2 new AAA alkaline batteries following the polarity (+ & -) orientation shown in the drawing.
PAGE 4
EASY LAUNCHING FOR BEGINNERS: Keep antenna pointed up WIND 20 metres (60 feet) or more Keep string tight ion rect LAUNCHING KITE di ind Release up Figure 9 W LAUNCHING KITE WITH ASSISTANCE Figure 8 1. 2. 3. 4. 5. Place your back to the wind – see Figure 8. The length of string should be 1 metre (3 feet). Swing kite up with nose pointing up. Keep spool tension trigger pressed. When the kite catches wind, carefully release the trigger to let string go out. 6.
PAGE 5
Wind Chaser™ Stunt Guide (continued) Left Side LEFT TRAVEL NEUTRAL LEFT NEUTRAL Right Side RIGHT RIGHT NEUTRAL TRAVEL NEUTRAL HOW TO MAKE THE KITE TRAVEL LEFT OR RIGHT You can move the kite to the left or right over a long distance when left or right side of the RC switch on remote is pressed and released (neutral position) repeatedly. DO SUPER EASY SPIRALS The kite will spiral if the left or right side RC Stunt Switch is held down continuously.
PAGE 6
WINDING UP THE STRING Point the remote to the kite and rewind the string by turning the Spool Crank Handle. If you feel the kite is hard to reel in because of strong wind, walk toward the kite and wind at the same time. Pay attention not to rewind the string at one edge of Spool all the time – wind the string onto the spool evenly. Do not pull the string in with your bare hands. Use the Line Winder Remote to crank it onto the spool.