Users Manual

ManualsBrandsSPERLL ManualsElectronicsLED Controller

SP630E is compatible with multiple types of LEDs.It can work with 1/2/3/4/5CH

W/CCT/RGB/RGBW/RGBCCT PWM and addressble LEDs, and it can also work with

addressble+PWM combined LEDs:

Summary of content (7 pages)

PAGE 1
SP630E is compatible with multiple types of LEDs.
PAGE 2
LED Type 1. High performance, low power consumption 2.4G Bluetooth microprocessor; 2. Compatible with 12 kinds of type of LEDs; 3. Support App control, 2.4G touch remote control and 2.4G touch 86-type control panel; 4. The remote control and 86-type control panel can be set up for zone-control (can be divided into 4 zones), or uniﬁed control (ALL); 5. Support to set kinds of on/oﬀ animations and the default power-on state. 6. Support for modifying device name, color order correction and setting timers. 7.
PAGE 3
Functions APP Pages LED Types Dynamic Colorful Static White Colorful White DIY DIM None 1 None 3 None 3 3 1 None 3 None 3CH PWM RGB 12 None HUE None 12 3 HUE CCT None 4CH PWM RGBW 12 5CH PWM RGBCCT 3 3 None HUE SPI Single Color None 10 None SPI RGB 146 None 146 10 SPI CCT None SPI RGBW 146 SPI RGBCCT SPI RGB+1CH PWM Single Color SPI RGB+2CH PWM CCT 146 146 10 10 3 3 CCT DIM None 3 18 18 5 HUE CCT HUE CCT HUE DIM 3 None None DIM 3 18 HUE HUE
PAGE 4
Click the icon in the upper right corner of the App to enter the settings page, where you can modify the name, modify the type of LED, calibrate the color order, set the timings, set the on/oﬀ eﬀect,etc. SP630E can be used with 2.4G touch remote control and 2.
PAGE 5
6 RC1 RC2 5 ON OFF 7 Brightness Level RC3 Warm/Nature/ Cold White RC4 8 White Color HUE/ Temperature Ring 25% Color HUE/ Brightness Brightness MODE MODE Speed Mode+ Mode- Brightness Ring Temperature Ring Color HUE Ring Temperature Ring Music eﬀect 1-4 Zones All Zones Note: 1.Within 20s after power on, long press the ON key: binding/unbinding the remote/panel; 2.
PAGE 6
Diﬀerent types of LED correspond to diﬀerent output ports; The ports should match the selected LED type, and the speciﬁc port descriptions as follows: LED Type VCC R G B Output Port CW WW DAT GND 7.FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 7
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.