Instructions / Assembly

88050959 10/11
3 GALLON PANCAKE COMPRESSOR
CALIFORNIA PROPOSITION 65
WARNING: You can create dust
when you cut, sand, drill or grind
materials such as wood, paint,
metal, concrete, cement, or other
masonry. This dust often
contains chemicals known to
cause cancer, birth defects, or
other reproductive harm. Wear
protective gear.
WARNING: This product or its
power cord may contain
chemicals, including lead,
known to the State of California
to cause cancer and birth
defects or other reproductive
harm. Wash hands after
handling.
Important!
When using equipment, a few
safety precautions must be
observed to avoid injuries and
damage. Please read the complete
operating manual with due care.
Keep this manual in a safe place,
so that the information is available
at all times. If you give the
equipment to any other person,
give them these operating
instructions as well. We accept no
liability for damage or
accidents which arise due to
non-observance of these
instructions and the safety
information herein.
Breathable Air Warning:
This compressor/pump is not
equipped and should not be
used as is to supply
breathing quality air. For any
application of air for human
consumption, the air
compressor/pump will need
to be fitted with suitable in-
line safety and alarm
equipment. This additional
equipment is necessary to
properly filter and purify the
air to meet minimal
specifications for Grade D
breathing as described in
Compressed Gas Association
Commodity Specification G
7.1 - 1966, OSHA 29 CFR
1910. 134, and/or Canadian
Standards Associations
(CSA).
CAUTION:
FOR YOUR OWN SAFETY
READ INSTRUCTION
MANUAL COMPLETELY AND
CAREFULLY BEFORE
OPERATING. Failure to
follow all instructions as
listed below may result in
electrical shock, fire, and/or
serious personal injury.
SPECIFICATIONS
Air Outlet: 1/4 inch ¼ NPT
Air Pressure: Auto shutoff @
100 PSI; Restart @ 85 PSI
Air Tank Capacity: 3 gallons
Air Flow Capacity: 0.6
SCFM @ 90 PSI; 1 SCFM @
40 PSI
Single Stage Pump Feature:
Overheat auto shutdown
and restart
ASSEMBLY
1) Ensure the power switch is
OFF and the unit is
unplugged.
2) Attach recoil hose to the
regulator manifold using an
open end wrench. Fully open
all regulators and valves.
3) Plug in the power cord.
Model: 50959
feedback@natitools.com

Summary of content (3 pages)