User's Manual

User Manual

SE-MANL-IRU1F-M2-EN-1

Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved by the part responsible

for compliance could void the user’s authority to operate the equipment

FCC-Class B

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a communications. However, there is no guarantee that

interference will not occur in particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

PAGE 1
User Manual SE-MANL-IRU1F-M2-EN-1 Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment FCC-Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a communications.
PAGE 2
User Introduction lhis USB irDA adapter aiiows you to establish a wireless gateway for a desktop or laptop PC to transfer data via its USB port, to and frorn a portable device, i.e. cellular phone, PDA, digital camera, or laptop PC, providing the portable device has the same IrDA capability. This adapter is small in size, only about 50 x 18 x 10mm, and the data transfer rate is up to 4Mbls with effective distance of about 1 meter ranqe.
PAGE 3
9. will automatically The Windows detect the USB IrDA adapter as "USB--Infrared adapter" and follow the on screen instruction automatic installation to install its required driver. Always choose when being asked. 10. Now, the USB IrDA adapter is ready to use. To check if the USB IrDA adapter is properly 2. Go to Device Manager Click on the "+" sign of the Infrared 3. A "USB--Infrared 1. installed Devices device should be displayed under this category Adapter" 4.