User's Manual

NP
actual
size
Install the latch and strike
P (2x)
C
A
B
slant of latch bolt faces
door frame
slant of latch bolt faces
door frame
A
B
C
D
Is the semi-circular hole of the latch centered in the door hole?
Is the door edge chiseled?
Install strike on the door frame.
Hold the latch in front of the door hole, with the
latch face lush against the door edge.
lush
YES NO
No adjustment is required.
Proceed to next step.
Move the pin to extend the latch.
door frame
YES NO
wood block
A / B
A
B
N (2x)
or
or
chiseled not
chiseled
2
1 / 4
66072001
Rev 01
ZWave® Plus
Installation and User Guide
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.kwikset.com/doorprep.
backset
Measure to conirm that the hole in
the door is 21/8" (54 mm).
*If you are installing this lever below
an existing lock or you plan to install a
lock above this lever, make sure that the
distance between holes is at least 61/2"
(165 mm).
Measure to conirm that the backset is
either 23/8" or 23/4" (60 or 70 mm).
23/8" or 23/4"
60 or 70 mm
See
note
below*
13/8" – 13/4"
35 – 44 mm
Measure to conirm that the hole in
the door edge is 1" (25 mm).
Measure to conirm that the door
is between 13/8" and 13/4" (35 mm
and 44 mm) thick.
A B C D
1"
25 mm
ENGLISH
21/8"
54 mm
Required tools
Ruler4 AA Batteries
Hammer Wood block
Phillips head screwdriver
Additional Tools (depending on application)
26298
27526 64156
22044
A
B
“B” is not included. If needed,
please contact Kwikset to order
a drive-in latch for your lock.
Levers
P
Z
UV
T
Parts in the box
Latch
Strike
Keys Spindle
Exterior
Assembly
Mounting
Plate
Fasteners
SmartKey
Tool
Interior
Assembly
C
M
K
L
F
G
F2E
H
Y2
Y1
N
Kwikset
Technical Support
1-866-863-6584
www.kwikset.com
1
Prepare the door and check dimensions