Installing the Outdoor Base Station Link Wireless Telephone System Part Number: 72-0050-00 Issue D Supplement to: 72-0075-01 and 72-0059-01
SpectraLink Corporation Installing the Outdoor Base Station Notice SpectraLink Corporation has prepared this document for use by SpectraLink personnel and customers. The drawings and specifications contained herein are the property of SpectraLink and shall be neither reproduced in whole or in part without the prior written approval of SpectraLink, nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith.
SpectraLink Corporation Installing the Outdoor Base Station WARNING: Changes or modifications to this equipment not approved by SpectraLink Corporation may cause this equipment to not comply with part 15 of the FCC rules and void the user’s authority to operate this equipment. WARNING: SpectraLink products contain no user-serviceable parts inside. Refer servicing to qualified service personnel.
SpectraLink Corporation Installing the Outdoor Base Station Table of Contents 1. About This Document 1.1 1.2 1.3 1.4 SpectraLink Corporation Model Numbers Related Documents Contacting SpectraLink Icons and Conventions 5 5 5 5 5 2. Installing Flush Against a Wall or Hard Ceiling 6 3. Installing on an I-Beam 8 4. Installing on a Light Pole or Electrical Pole 9 PN: 72-0050-00-D.
SpectraLink Corporation 1. Installing the Outdoor Base Station About This Document The Outdoor Base Station is designed to withstand environmental hazards such as rain and excessive heat and cold. The outdoor enclosure is mounted into position and the Base Station is then installed within it. The entire unit is then referred to as an Outdoor Base Station. This document covers the installation of the Outdoor Base Station in a variety of situations.
SpectraLink Corporation 2. Installing the Outdoor Base Station Installing Flush Against a Wall or Hard Ceiling Items provided: Outdoor enclosure, Base Station Items needed: 4 anchor bolts (length and type depends on wall or ceiling material Base Station is being mounted to) 1. Mark and drill 4 holes into the wall or ceiling, using the mounting flanges of the outdoor enclosure as a guide. 2. Mount outdoor enclosure to wall or ceiling using anchor bolts.
SpectraLink Corporation Installing the Outdoor Base Station 5. Plug the RJ45 into the RJ48C connector. Mounting hole RJ48C connector 6. Place the Base Station into the enclosure with the side of the Base Station with the mounting hole facing the wall or ceiling. The Base Station should fit tightly into the foam blocks. 7. Screw the outdoor enclosure lid back onto the enclosure. PN: 72-0050-00-D.
SpectraLink Corporation 3. Installing the Outdoor Base Station Installing on an I-Beam Items provided : Outdoor enclosure, Base Station Items needed : 4 - “Caddy” or “B-Line” 3/8” Beam Clamps 4 - ½” ¼” x 20 bolts 4 - 2” ¼” x 20 bolts 4 - ¼” x 20 nuts 1. Attach a beam clamp to the center of the top and bottom flanges on the outdoor enclosure. 2. Attach a second beam clamp to each of the beam clamps on the enclosure using a ½” ¼” x 20 bolt and a nut. (See Picture Below) 3.
SpectraLink Corporation 4. Installing the Outdoor Base Station Installing on a Light Pole or Electrical Pole Items provided: Outdoor enclosure, Base Station Items needed: 4 - “Caddy” or “B-Line” 3/8” Beam Clamps 2 - EOG 100 or Equivalent Band Clamps 1. Attach one band to the top flange of the outdoor enclosure using 2 beam clamps (see the figure below). 2. Attach the second band to the bottom flange of the enclosure using the remaining 2 beam clamps. 3.