SPECTRA T1000 無 線 POS 終 端 機 EFT-POS 安裝指南 Installation Guide Version 1.
SPECTRA T1000 目錄 Table of Content 1. T1000 設計及功能介紹........................................................................2 Layout & Function Descriptions of T1000 1.1 主機及配件 Main Unit & Accessories......................................................................... 2 1.2 組件特徵 Features at a Glance.................................................................................. 3 1.3 安裝 SIM、SAM 及 Micro-SD 卡 Installation of SIM, SAM & Micro-SD Card.............. 4 1.4 安裝電池 Battery Installation.........
SPECTRA T1000 1 T1000 設計及功能介紹 Layout & Function Descriptions of T1000 1.1 主機及配件 Main Unit & Accessories 終端機 - 處理交易流程、密碼輸入、 打印、處理通訊及其他用戶介面， 如電子收銀機連線等。 Terminal - for transaction processing, PIN entry, printing, communication and other peripheral interfaces such as ECR integration 7.4V 充電電池 ) ( 7.
SPECTRA T1000 出紙口 Paper Outlet 1.
SPECTRA T1000 1.3 安裝 SIM、SAM 及 Micro-SD 卡 Installation of SIM, SAM & Micro-SD Card SAM 卡 SAM Card 1 Micro-SD 卡 )可選配( 2 Micro-SD Card (Optional) SIM 卡 )可選配( SIM Card (Optional) 1.
SPECTRA T1000 1.5 送紙程序 Paper Feeding Procedure 1 升高紙盤開啟桿 Lift up the Paper Tray Lever 2 把紙盤開啟桿往後拉 Pull the Paper Tray Lever backward 3 將紙卷如圖放入紙盤 Place the paper roll into the tray as shown 4 關上紙盤蓋 Close the Paper Tray Cover 紙卷大小 Paper roll size 57mm (2 1 ") 4 安裝指南 Installation Guide 40mm Max.
SPECTRA T1000 2 如何操作 How to Operate 2.1 開 關 程序 Turn On/ Off Procedure 終端機如裝備有 充電 電池及首次使用，請 先將電源接上， 充電 三小時。 開機 - 將電源接上，終端機會自行啟動。 如沒接上電源，請按 鍵數秒開機。 啟動後，屏幕顯示應用程式預備畫面， 此時閣下可進行各類型交易操作。 關機 - 將電源供應器拔去，按 秒關機。 鍵數 If the terminal is equipped with charging battery during first time use, please connect the power adaptor and charge the battery for 3 hours. On - Power is on whenever plugged. If the terminal is unplugged, press the key for several seconds to turn on the terminal.
SPECTRA T1000 3 充電電池安全使用指引 Rechargeable Battery Safety Guideline 3.
SPECTRA T1000 3.3 機器及電池儲存指引 Terminal and Battery Storage Guideline 若機器長期閒置，請將電池充至僅 50% 滿 後拆離機器)即電池顯示一半滿，٢格時(， 並置於陰涼地方，以減低自行放電耗盡引 致失效的機會 切勿將電池與金屬物品一起放置，並避免 潮濕、高溫的環境 於儲存期間，建議每三個月將電池滿充一 次 If the battery will not be used for a long period, please charge it to only 50% of the battery capacity (battery indicator displays half full, 2 units); remove it from the terminal and store in a cool place.
SPECTRA T1000 4 安全及維修 Safety & Maintenance 4.1 基本安全規範 Basic Safety Practice 使用 T1000 及相關設備時，必須遵循如下基 本安全規範以防範火災、電擊以及個人傷害： 詳細閱讀並理解所有的提示 清潔機身前必先拔開電源和外設，使用乾絨 布或軟刷子進行清潔 請勿在靠近水的地方使用設備 禁止將任何液體濺落到設備上 While using T1000 and its accessories, please follow the safety instruction to avoid fire, electric shock and personal injury.
SPECTRA T1000 4.
SPECTRA T1000 清潔印表機 Printer Cleaning 分開終端與電源線的連接 Disconnect power cable from the terminal 開啟紙斗蓋, 取出軸心及紙卷 Open printer cover, take out paper and roller 清除紙斗中的紙屑及灰塵，如果可能的話，可 使用低壓吹風器 不要觸摸打印機頭及切紙刀 Remove dust and paper scrap inside paper tray . Use low pressure blower to clean the paper tray if possible.
SPECTRA T1000 打印機工作不正常 ۱、如終端機只從電池供電，請給電池充電或更換 電池，如問題仍未解決，嘗試從電源適配器 供電 ٢、如從電源適配器取電，檢查電源線接口、電源 適配器接口是否穩固地插牢 ٣、開啟紙斗蓋，檢查紙卷是否已用完 ٤、檢查打印紙安裝是否正確，請參閱 ۱٫٥ 節 ٥、打印機只接受熱敏打印紙，請檢查是否已使用 適當的打印紙，請參閱 ۱٫٥ 節 ٦、檢查打印紙是否被卡住或破損，請嘗試開啟紙 斗蓋，重新整理打印紙 7、如問題仍未解決，請與代理商聯繫 Malfunction on printer 1, If the terminal is powered by battery, check the battery level and charge the battery, replace new battery or else power the terminal by adaptor.
SPECTRA T1000 5 其他資訊 Other Information 尺寸及重量 Dimensions & Weight 尺寸: 171 (長) x 88 (闊) x 61 (高) mm (不包括凸出部份) Size: 171 (L) x 88 (W) x 61 (H) mm (Excluded protruded part) 重量: 490克 (終端機連電池) Weight: 490g (Terminal with battery) 工作環境 Operating environment 溫度: 0 C - 45 C 濕度: 0% - 85% (非冷凝) Temperature: 0 C - 45 C Humidity: 0% - 85% (non-condense) 電源輸入 Power input DC 9V, 3A DC 9V, 3A 產品認證信息 Message for product approval 本產品符合以下認可標準 This product complies with the following standards 歐盟認證 CE approva
SPECTRA T1000 Notes 安裝指南 Installation Guide
無 線 POS 終 端 機 T1000 EFT-POS 瑞柏科技控股有限公司 香港 九龍 193號 電話 : (852) 2319 2918 傳真 : (852) 2319 2631 1301-09, 19-20 SPECTRA TECHNOLOGIES HOLDINGS CO.LTD. Unit 1301-09,19-20, Tower II, Grand Century Place, 193 Prince Edward Road West, Kowloon, Hong Kong Tel : (852) 2319 2918 Fax: (852) 2319 2631 www.spectratech.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
locations (e.g., worn on the body) as required by the FCC for each model. when worn on the body, as described in this user guide, is 0.956W/Kg. (Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure.
