Technical Manual 3. Options 34 32 3.3 TO1 Programmable Channel Spacing The MX 300 receiver is available in five different channel spacing options. For Applications in Systems Which reacquire both 12:5 Fz und 2 kHz channel spacing option TOT allows channels to be programmed for either bandwidth. Switchable IF filters. in the receiver and automatic. | gain compensation in the an div paths make the change in bandwidths transparent £0 the user: This caption. must be specified at order placement. Once.
MXB00 Transceiver Technical Manual 3.4704 Balanced and Isolated VF Standard VE Segregationist to Site are 000k So wire unbalanced: Option TO4 ‘may be fitted if transformer balanced and isolated VE inputs and outputs are required: A transformer PCH. is ed internally. at the rear of the MXS80U, This POE has a RIO connector (CN) which protrudes. through. the. Tear panel ‘whe this Option is fitted ‘and the: balanced VE outpost are: made: available vis semiconductor. Note that theses. connections are.
Technical Manual Cpl ions: 3.5" T05 Balanced and Isolated VF plus E&M Option TOS provides the balanced and isolated VF 0 as per option TM as well as isolated E (PTT) and leads, Nate: Jumpers referred to in the table below are those on this option FCB. ‘The E lead:is opt isolated and may be asserted by applying a: DC voltage between. SN. and 48. with.any. polarity: between CNO. Pins. 7&8 (IMP. 411 position 2-3; IMP removed}. Provision is also made to internally source the activation. voltage. DC).
MX800 Transceiver ‘Technical Manual 3.4. T04 Balanced -and Isolated VF Standard VE connections lo June are. 600ohm. 4-wire unbalanced. Option T04. may be fitted if transformer balanced and isolated VF inputs and outputs sre required A ans Comer PUBS Tired internally” at’ the veal” of the MXB00! This: PCB has ‘a [R145 connector (CNS) which protrudes: through the rear panel. when this option -is-fitted and the balanced VE outputs are: made available via this commentator.
Charterer Hosier Options 3.5 T05 Balanced and Isolated VF plus E&M Option: 105 provides: the balanced and isolated VP HO-us per-caption To as well as isolated (PTT) and M (Mute) leads. Note. Jumpers referred to.in the. table below are those on this option PCB: The Blend is opt isolated ad ins be ass cried by applying a DC Voltage between SV and 48V with any. polarity between CNO Pins 748 (IMP in position. 2:3; MIME remarked. Provision is. lase made fo internally source the.
MXB00 Transceiver: Technical Manual 3:6 3.7 3.8 TO6 Simplex Changeover Relay For simplex applications an internally: mounted coaxial changeover relay can be provided: This: mounts on the rear pane] and the common port protrudes through the chassis providing the simplex: antenna connection.
Historical tsa o Opens. IP | Deconstructionism. =~ | Option Active. | Option Disabled. MP1 Low standby current mode Out In Sikh ei BoE Mp Li Sindbad current node Out Ta switched receiver power IMP 3 300Hz Efficacy filer 1-2 2:3 MP4 RX Audi delay 2-3 1-2 Table 3-3. Option PUB Link Settings Refer diuretic Ga gram CSONKA Suppression Upgrade Filter This ‘option provides upgraded CSS tome suppression on the RX VF.
OXBOW Transceiver Technical Manual 3.10 T10 Low Standby Current Mode For solar powered sites and either power: critical applications the MX800 is capable of a; Tow Standby Current Mode: This option can be implemented in {here-stuges; Stage ong implementation Replaces the ‘micro controller linear Tagged regulators bewitchment regulators: Response times are unaffected: Stage: twa involves removing power. from the exciter when the: acid is in standby:mode. In this case RX responses times are unaffected.
Technical Malaysian Bioreactor IME | Pedestrianization. Option Active | Option Disabled IMP Low standby current mode: Quy In switched Dexter power IMP 2 | Low standby current mode Out In switched receiver power. 3 B01 Flipped fair + 12 3 IMP 4. RX audio delay BF 22 Table 3:6 Option PCB Link Se dingy Refer circuit diagram €CS022-1 3.11.T11. Combined Options “This option combines the fund ions and realizes oF TUS TOS and THY 3.12 T12 External Reference Oscillator Input The: MXS00 receiver “and.
MXBGQ Transceiver Technical Manet 3.13 T13 Local Speaker and Mic For applications needing a age interface at (he base: station the MXB00 is ‘available with the Local Control option. When: fully implemented the Front Panel #s-as illustrated below, 1t has the saws LED indicators as the standard front panel as well as the following features Channel Loud | Volume | Monitor Microphone. | §squelch Ling O/% Change | Speaker. Gorgon | Port Adjust Adjust Figure 3-3. Front Panel (Fully implemented) #.
Technical Manual Options: behind the from panel. A screwdriver Hole is provided in the front panel To aces this adjustment, 4... Line JO Level Adjustment: Provision is made to optionally locate the ling in and line gut Evil potentiates behind the front panel. A screwdriver hole is provided Alongside the squelch-adjustment hole in: the: front panel. to access this adjustment. Note: Note that it is possible to select some satires of the Local Conical Option"and vomit Givers.