Speco Technologies 200 New Highway • Amityville, NY 11701 For more information on our products go to: www.specotech.com or contact us at: 1-800-645-5516 www.specotech.com 5x4 Multi-Source/Multi-Zone Matrix Distribution P.A.
IMPORTANT! Please read this manual carefully before operating this unit for the first time. All rights reserved to Speco Technologies. All features and content might be changed without prior notice. Any photocopy, translation, or reproduction of part of this manual without written permission is forbidden.
SAFETY RELATED SYMBOLS Unplug the product before electrical storms occur and when unused for long periods of time to reduce the risk of electric shock or fire. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol, wherever used, alerts you to the presence of un-insulated and dangerous voltages within the product enclosure. These are voltages that may be sufficient to constitute the risk of electric shock or death.
To avoid the risk of electric shock and damage, do not subject this product to any liquid/rain or moisture. Do not use this product when in close proximity to water. Servicing Refer all servicing to qualified service personnel only. Do not perform any servicing other than those instructions contained within the User's Manual. Do not install this product near any direct heat source. Do not block areas of ventilation as doing so could result in fire. Keep product away from open flames.
G - + COM 4 8 25V 19. AC Voltage Selector In the US, set the AC Voltage Selector to the left (115V) for power between 100V and 127V. 70V 19 20.Monitor Line Out Monitor Line Out can be connected with another appliance such as an amplifier, recorder, etc. 0 0 70V 70V Connecting the speakers with 70V output 0 70V 21.Monitor 1W8 The terminal is meant for the connection of a small external loudspeaker that gets driven by an internal auxiliary power amplifier, providing a nominal output of 1Watt.
SPECIFICATION Model: The Front panel PL200M Output power c apacity: RMS:40W 4; Peak output: 90W 4 Frequency response: 50-17000 Hz (-3dB) Totalh armonic distortion: Less than 0.5%(1KHz-nominal power capacity) Signal/noise r atio: Inputs / sensitivity-impedance: CH 1 CH 2 CH 3 CH 4 CH 5 PL200M MULTI-ZONE DISTRIBUTION P.A.
11. Zone1 VOLUME VOLUME controls the output signal level of ZONE1. 12.LED VU-meter This stereo 6 segment LED-meter indicates the level of the overall output signal. 12 13.MONITOR selector Pushing the MONITOR button down will connect the signal from amplifier zone 1 to the monitor output. Releasing the button will then cut off the signal connection to the monitor. The other three buttons are operated in the same way.
26.The mono MIC/LINE channels G - + COM 4 8 25V 70V The channels are numbered from 1 to 4. You can connect balanced, low impedance microphones to the XLR socket. On the 1/4" phone jack you can connect either a microphone or a line level instrument. You should never connect an unbalanced microphone to the XLR socket as it could damage both the Microphone and the Mixer. 26 27.
