Installation Guide

INSTRUCTIONS FOR MODELS
92-SEF-9200-02
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
[e-mail]
www.speakman.com
SEF-9200
Works With:
SPEAKMAN SC-581X / 583X / 585X Faucets
Ferguson ProFlo PF1119
Fiat 830AA
TOOLS AND SUPPLIES
IMPORTANT
SAFETY TIPS
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
MAINTENANCE
The eyewash valve has a rubber seat washer, which
may require periodical maintenance. The eyewash unit
can be cleaned using a mild soap and warm water
solution. Rinse thoroughly and dry immediately with a
soft, clean cloth for best results.
WARRANTY
Additional warranty information can be found at:
www.speakman.com
Be sure to read instructions thoroughly before beginning
installation. Do not overtighten any connections or damage
may occur. The supply line for plumbed eyewash units shall
provide an uninterruptible supply of flushing fluid at a
minimum of 30 psi flowing pressure. If a shut off valve is
installed in the cold supply line of the sink fitting (which
supplies the eyewash) for maintenance purposes, provisions
shall be made to prevent unauthorized shut off. The sink
fitting does not have to be turned on for the eyewash to
operate. ANSI Z358.1 requires that all emergency
equipment shall be tested weekly to verify proper operation
and inspected annually to assure conformance with ANSI
Z358.1-2009 requirements.
LevelPhillips
Screwdriver
Adjustable
Wrench
Thread Seal
Tape
5/16” Hex
Key Wrench
Measuring
Tape
Pencil
1
After shutting off water supplies, remove the
Cold Supply Stop from Faucet.
2
After cleaning the seat, thread the Stop Adapter
into the Cold Supply Stop location of Faucet.
Wrench tighten.
3
Tighten the Threaded Insert to create a seal
between the Sink Fitting and the Adapter using
a 5/16” Allen Wrench in the base of the
Adapter.
4
After applying Thread Sealant Tape, thread the
Vacuum Breaker Assembly (1) onto the Stop
Adapter. Wrench tighten.
5
Attach Hose end to the the Vacuum Breaker
Assembly. Wrench tighten.
6
After reviewing the Roughing In Diagram, select
a suitable location for installation. Using the
Mounting Bracket as a template, transfer
mounting locations to wall using a pencil.
Be sure Bracket is level and plum.