Installation Guide

ManualsBrandsSpeakman ManualsSafety AccessoriesHeat Traced Combination Emergency Shower and Eye/Face Wash with Top Supply

Installation,

Operation and Maintenance

Instructions

Speakman Company Safe-T-Zone

Heat Traced Emergency Stations

You have selected the designated item:

 SE-7001

OTHER:_________________________________________________________

SERIAL NO:_____________________

3/08 Rev-3

92-2904

Summary of content (6 pages)

PAGE 1
Installation, Operation and Maintenance Instructions Speakman Company Safe-T-Zone® Heat Traced Emergency Stations You have selected the designated item: SE-7001 OTHER:_________________________________________________________ SERIAL NO:_____________________ 3/08 Rev-3 92-2904
PAGE 2
INSTALLATION INSTRUCTIONS SECURING UNITS 1. SE-7001 is equipped with a cast floor flange. Suitable anchors must be used to ensure that the unit is rigid and properly secured before being used. NOTE: If desired or required, additional straps or braces can be used to secure any unit. (BE SURE NOT TO DRILL OR SCREW ANYTHING INTO THE OUTER PLASTIC SHELL.) PLUMBING CONNECTION 1.
PAGE 3
4. Apply a thread sealant and attach shower head to 1" nipple on upper shower arm. Fasten lever handle with screw located in extension. Secure pull rod to lever handle. PLUMBING NOTES 1. The primary function of this unit is to keep water from freezing. 2. When possible, install unit in an area protected from direct blast of prevailing winter winds, to minimize wind chill factor. 3. BE SURE WATER SUPPLY PIPING IS PROTECTED FROM FREEZING. ELECTRICAL CONNECTION 1.
PAGE 4
ELECTRICAL NOTES 1. Make sure power supply is in compliance with National Electric Code (N.E.C.). 2. Be sure electrical supply is NEVER TURNED OFF DURING COLD WEATHER! 3. If you have a unit without a stanchion light, you are required to light the area where your unit is installed. OPERATION / TESTING 1. Once electrical connections are complete and unit is assembled and plumbed, test unit to verify water flow by activating the eye/face wash. 2. Activate the shower by pulling the pull rod.
PAGE 5
REPLACEMENT COMPONENTS Standard Items for all units: 1 2 3 4 5 G05-0716 G38-0211-MO G47-0046-29 04-0547 04-0524 Eye/face wash assembly Deluge shower head Aluminum Pull rod assembly Stainless lever for shower valve Paddle handle for eye/face wash Not Shown: 03-0515 03-0516 03-0513 03-0514 Stem extension for ½” ball valve Drive extension for ½” ball valve Stem extension for 1” ball valve Drive extension for 1” ball valve Components that are not listed, are factory installed and not recommended for field
PAGE 6
SE-7001 SERIES ROUGH-IN AND REPLACEMENT PART COMPONENTS