Installation Guide

SPEAKMAN COMPANY
SE-400 Installation, Maintenance & Operation Instructions
EYESAVER® EYE/FACE WASH
DESCRIPTION
Emergency eye/face wash for wall mounting, supplied with stainless steel bowl, stay-open full flow ball valve;
activated by stainless steel push handle; in-line strainer, and heavy duty wall mounting plate. Spray pattern is a 9”
x 8” (72 sq. in.) curtain of aerated water, easily controlled at any pressure for maximum protection.
SPECIFICATIONS
BOWL: 300 Series Stainless Steel.
SPRAY HEADS: (6) Brass, Chrome-Plated Aerated.
VALVE: 1/2” NPT Female Brass, Chrome-Plated.
ACTIVATOR: Stainless Steel Push Handle.
SHROUDS: Yellow Polypropylene.
INLET: 1/2” NPT Female.
STRAINER: Brass, Chrome-Plated, In-Line.
PLATE: Cold-Rolled Steel, Safety Green Powder Coating.
SHIPPING WEIGHT: 14.13 lbs.
EMERGENCY SIGN: 7-7/8” x 7-7/8” Plastic Wall Sign.
OPTIONS
INSTALLATION
Review drawing (as shown on other side) to assure proper installation. The unit should be mounted to a structural
member that will ensure structural rigidity. Use appropriate wall anchors and be sure the wall bracket is level to
ensure proper flow pattern, and to avoid unnecessary water spillage. Connect a water supply to the unit (use pipe
sealant on all joints) that is a 1/2” minimum uninterrupted source of potable water. Failure to use potable water can
result in emergency units producing impure or contaminated water causing possible further injury. The drain
tailpiece or waste should be connected to an adequate drain in compliance with local plumbing codes. Once water
supply is connected to unit the spray pattern can be manually adjusted by using a flat head screw driver to rotate
the adjusting screw, located in the front of each shroud assembly, while the unit is activated and water is flowing.
OPERATION
The eye/face wash is activated by pushing the push handle back 90°. The unit will operate until the push handle is
manually pulled back up to the off position.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be activated on
a weekly basis to flush the line and verify proper operation. Speakman Company furnishes a testing record tag
(91-0635) with each unit. On this tag the date of inspection and the inspectors initials should be noted.
◊ AL1
(Air Horn Alarm) ◊ HFO (Hand & Foot Operation)
◊ AL3 (Electrical Alarm) ◊ PT (1-1/4” Dia. P-Trap)
◊ AL2-C1D2 (Electrical Alarm / Haz.
Area)
◊ FPV
(Anti-Freeze Protection Valve)
◊ AL3-C1D2 (Electrical Alarm / Haz.
Area)
◊ SPV
(Anti-Scald Protection Valve)
◊ FLW (Flow Switch) ◊ SSBV2 (1/2” Stainless Steel Valve)
◊ HS (Hand-held Spray) ◊ VPL (Vapor Proof Light)