Quick Start Guide

ManualsBrandsSpeaker Electronic ManualsElectronicsActive PA Column System

GETTING STARTED

The subwoofer of C6, as well as the

subwoofer extension C6 SE must be

placed on level ground, standing on

its rubber feet.

Ensure adequate cooling during

operation with a minimum distance

of 50 cm between the subwoofer’s

back panel and other objects such as

walls.

Always turn on the C6 system

last and turn it off first to avoid

damaging the speakers.

Never assemble the system with

other than the intended two

columns.

GETTING STARTED

Quick start guide

This guide briefly describes the main steps of setting up a C6

column system in stereo mode.

Precautions

50 cm

Temp.

POWER

Turn ON last

Turn OFF first

Summary of content (6 pages)

PAGE 1
GETTING STARTED EN Quick start guide This guide briefly describes the main steps of setting up a C6 column system in stereo mode. Precautions The subwoofer of C6, as well as the subwoofer extension C6 SE must be placed on level ground, standing on its rubber feet. Ensure adequate cooling during operation with a minimum distance of 50 cm between the subwoofer’s back panel and other objects such as walls. Always turn on the C6 system last and turn it off first to avoid damaging the speakers.
PAGE 2
GETTING STARTED EN Assembly How do I assemble the C6 column system? 1 Place the subwoofer at the desired location. 2 Slide the support column’s four metal pins in the according slots located at the subwoofer’s top. The multi-pin connectors will automatically be coupled. Array column Support column 3 Plug the array column in the support column similar to the instructions of step 2 . Subwoofer Do not wobble the columns too strongly during assembly or disassembly, as this may cause damage to the product.
PAGE 3
GETTING STARTED EN Recommended minimum audience distance 3-4 m 1,2 m The ear level height of seated audiences is around 1,2 m in average. In the setup shown above the recommended min. distance between the C6 system and the listeners should be no less that 3-4 meters. User interface Rear panel A B C PRODUCT SERIAL NUMBER Tell this code to the customer support, if you are in need of help. A POWE R POWER SWITCH Turn the whole system on/off. is ON and is OFF position.
PAGE 4
GETTING STARTED EN Mixer overview: connectivity D E F H G F 6,35 mm Hi-Z TSR G COMBO LINE IN L/R (XLR/6,35 mm jack TRS) H COMBO MIC IN (XLR/6,35 mm jack TRS) I XLR LINE OUT (C6 SE Subwoofer Extension) J XLR SYSTEM OUT K RCA L/R TO C6S E I D E J K BLUETOOTH® 4.
PAGE 5
GETTING STARTED EN SUB LEVEL ROTARY KNOB Adjust the subwoofer volume relative to the main volume. L MAIN LEVEL ROTARY KNOB Adjust the total system volume. M MAIN INDICATORS ON LED Green color indicates that the system is turned ON. SIGNAL LED Green color flashes according to the input signal level. LIMIT LED Red color, indicates that the DSP limiter is triggered. PROTECT LED Indicates the system has shut down to protect its components from damage. The amplifier output is muted automatically.
PAGE 6
GETTING STARTED EN Audio input Bluetooth® How do I pair my audio source device with the C6 via Bluetooth®? Make sure that your device is compatible with Bluetooth® v4. Profiles: A2DP v1.2 & AVRCP v1.4 1 POWER ON the C6 system. The BLUETOOTH LED should emit a constant blue light indicating that the module is on. (see “BLUETOOTH” on p.14) Each time you power on the C6, it will try to re-establish a connection with the previous device. 2 Press and hold the PAIRING BUTTON “HOLD TO LINK“ for at least 3 seconds.