WLAN Compact USB Adapter USER’S GUIDE VERSION 1.
© All rights reserved. All trade names are registered trademarks of respective manufacturers listed. This manual may not be copied in any media or form without the written consent of original maker.
Information To User ..................................................…….. i 1. Introduction .........................................................….. 1 2. Wireless LAN Basics ................................................……..3 3. IP ADDRESS ..........................................................……..4 4. Install Driver/Utility ...............................................……..5 5. Wireless Network Configuration ................................……… 7 5.1 General Connection Setting ...................
INFORMATION TO USER Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
802.11g WLAN Compact USB Adapter is limited in Ch1~Ch11 by specified firmware controlled in U.S.A. REGULATORY INFORMATION 802.11g WLAN Compact USB Adapter must be installed and used in strict accordance with the instructions. This device complies with the following radio frequency and safety standards. USA - Federal Communications Commission (FCC) This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2.
The channel identifiers, channel center frequencies, and regulatory domains of each 22-MHz-wide channel are shown in following Table.
Thank you for your purchase of the 802.11g WLAN Compact USB Adapter. Featuring wireless technology, this wireless networking solution has been designed for both large and small businesses, and it is scalable so that you can easily add more users and new network features depending on your business scale. FEATURES Support Microsoft Windows 98SE, Me, 2000 and XP. Operating distance of up to 300 meters in free space. 54/48/36/24/18/12/11/9/6/5.5/2/1 Mbps selectable Data Rate. Support USB 2.0 interface.
BEFORE YOU START 1. Confirm Box Contents CONNECTING YOUR WLAN Compact USB ADAPTER TO PC Quick Start Guide Connect your WLAN Compact USB Adapter to your PC. Install driver. GETTING TO KNOW WIRELESS LAN USB ADAPTER LED LED turns on when POWER is applied to the 802.11g WLAN Compact USB Adapter. LED is blinking when PC is sending data through 802.11g WLAN Compact USB Adapter.
Wireless LAN network defined by IEEE 802.11b/g standard committee could be configured as : Ad Hoc wireless LAN, or Infrastructure wireless LAN. Ad Hoc network is a group of PCs installed with wireless LAN cards, this group of PCs is called a BSS (Basic Service Set). PCs in this group can use their wireless LAN cards to communicate with each other, but can not connect to the Internet.
To use the 802.11g WLAN Compact USB Adapter with a computing device, the 802.11g WLAN Compact USB Adapter must be equipped with an USB 1.1 or 2.0 Interface. All drivers and supporting software for the 802.11g WLAN Compact USB Adapter must be installed and configured first. Ask your system administrator for the following information, which you may need to provide during driver installation : Your Wireless Client Name. Your Wireless SSID. Your computer’s unique client name and workgroup name.
The installation & driver CD will automatically activate the autorun installation program after you insert the disk into your CD drive. Step 1 : Insert the installation & driver DC into your CD-ROM. Step 2 : Click Next to continue. Step 3 : Click Next to install at the designated folder. Or, click “Browse” to select different folder.
Step 4 : Start copying files until it finishes the installation. Step 5 : Click Finish to complete installation. Step 6 : After finished install driver and utility on your system, plug the 802.11g WLAN Compact USB Adapter into the USB port of your PC. Windows XP/2000 will automatically detect the802.11g WLAN Compact USB Adapter.
WLAN USB Adapter uses its own management software. All functions controlled by users are provided by this application. When you insert the WLAN USB Adapter into the USB port of your PC, a new icon should appear in the Windows System Tray automatically. If the icon is in red, it means that WLAN USB Adapter configuration is invalid or incomplete. Double click on that icon and the configuration window will pop up as shown below. It shows the SSID of available network.
5.1 GENERAL CONNECTION SETTING In this panel, you can modify the general network connection setting, enable/disable the WEP, load/ modify profile and other setting. Through this control panel, you will be able to access the corporate wireless LAN or hot spots such as hotel, airport, and conference hall. Click “Change” to start input of settings. The settings include : SSID. Network Type. Transmit Rate. Encryption. Authentication Mode. When settings are input, click “Apply” to confirm changes of them.
5.2 WEP ENCRYPTION KEY SETTING You may want an additional measure of security on your wireless network, which can be achieved by using WEP (Wired Equivalent Privacy) encryption. WEP encrypts each frame transmitted from the radio using one of the Keys entered in this panel. When an encrypted frame is received it will only be accepted if it decrypts correctly. This will only happen if the receiver has the same WEP Key used by the transmitter. The default state in Encryption Setting is WEP disabled.
5.3 WPA ENCRYPTION SETTING WPA (Wi-Fi Protected Access) is a security technology for wireless networks. WPA improves on the authentication and encryption features of WEP (Wired Equivalent Privacy). To improve data encryption, WPA utilizes its Temporal Key Integrity Protocol (TKIP).
5.4 PROFILE Each profile represents specific settings of the WLAN USB adapter. You can set the settings for each profile. Next time when you want to change the WLAN USB adapter settings, you can just select the profile you want to use.
5.5 ADVANCED SETTING Click “Advanced Setting” to select power consumption setting that has 3 different modes. In this panel, you can select different user interface and country roaming. It also allows you to set the threshold of fragmentation and RTS/CTS.
5.6 SYSTEM INFORMATION Click “Information” and the pop-up window will show the Driver Version, Utility Version, MAC address of this USB adapter and so on.
Product Name 802.11g WLAN Compact USB Adapter Standard IEEE802.11b/g Frequency Band 2.400GHz ~ 2.4835GHz unlicensed ISM band Modulation method Data Rate Operation mode Transmitter Output Power Receive Sensitivity 802.11b : QPSK/BPSK/CCK 802.11g : OFDM 54/48/36/24/18/12/11/9/6/5.5/2/1Mbps Ad hoc Infrastructure (Access Points is needed) < 13.
Symptom : The LED is off. Remedy : Make sure the PC Card is inserted properly. Otherwise contact your vendor. Symptom : The LED is always on not blinking. Remedy : Make sure that you have installed the driver from attached CD. Otherwise contact your vendor. Symptom : The LED is blinking but the PC Card icon does not appear in your icon tray. Remedy : Make sure that you have installed the Utility from the attached CD. Symptom : The PC Card is linking, but can’t share files with others.
IEEE 802.11 Standard The IEEE 802.11 Wireless LAN standards subcommittee, which is formulating a standard for the industry. Access Point An internetworking device that seamlessly connects wired and wireless networks together. Ad Hoc An Ad Hoc wireless LAN is a group of computers, each with a WLAN adapter, connected as an independent wireless LAN. Ad Hoc wireless LAN is applicable at a departmental scale for a branch or SOHO operation. BSSID A specific Ad Hoc LAN is called a Basic Service Set (BSS).
Ethernet Ethernet is a 10/100Mbps network that runs over dedicated home/office wiring. Users must be wired to the network at all times to gain access. Gateway A gateway is a hardware and software device that connects two dissimilar systems, such as a LAN and a mainframe. In Internet terminology, a gateway is another name for a router. Generally a gateway is used as a funnel for all traffic to the Internet.
Protocol A protocol is a standardized set of rules that specify how a conversation is to take place, including the format, timing, sequencing and/ or error checking. Roaming In an infrastructure network, this is when a wireless PC moves out of range of the previously connected access point and connects to a newly connected access point. Throughout the network environment where access point is deployed, PCs can always be connected regardless of where they are located or roam.
Transmission Control Protocol / Internet Protocol (TCP/IP) TCP/IP is the protocol suite developed by the Advanced Research Projects Agency (ARPA). It is widely used in corporate Internet works, because of its superior design for WANs. TCP governs how packet is sequenced for transmission the network. The term “TCP/IP” is often used generically to refer to the entire suite of related protocols. Transmit / Receive The wireless throughput in Bytes per second averaged over two seconds.
Wireless LAN (WLAN) A wireless LAN does not use cable to transmit signals, but rather uses radio or infrared to transmit packets through the air. Radio Frequency (RF) and infrared are the commonly used types of wireless transmission. Most wireless LANs use spread spectrum technology.
One Year Limited Warranty This device is guaranteed against manufacturing defects for one full year from the original date of purchase. This warranty is valid at the time of purchase and is non-transferable. This warranty must be presented to the service facility before any repair can be made. Sales slip or other authentic evidence is required to validate warranty. Damage caused by accident, misuse, abuse, improper storage, and/or uncertified repairs is not covered by this warranty.
