AMENITY Installation Manual & Operation Instructions he SHAVED DOOR KIT MODELS: SHAVED SHAVED-2-ACT SHAVED-2-SILL MADE IN THE U.S.A. Note: Read this instruction manual thoroughly before installation. TECH SUPPORT: 800-454-7725 Rev.
Pro Start 3300 PARTS LIST: (1) Tartar Control Modular (8) Heavy-Gauge Single-Pin (1) 128 db Siren Wire Harness (1) Hack Sponsor {1) Recelver/Antanna Module: (1) 10-Pin Wiring Harness {1} Receiver/antenna Cable £1) Threw-Pin Wiring Harness (1) Status LED {1) Four-Pin Wing Harness (1) Programmatic Switch: {1) Hood Pin Switch (2) 4-Button RF Tran emitters ECC statement This device complies with Part 15 FCC Rules.
Installation instructions for AMENITY Shaved Door Handle Kit This kit is designed to operate two or more functions. Both doors and five other functions can be controlled with the AMENITY four-button remote control. The additional channels can be used to operate power door releases, trunk releases, roll up or down power windows or control linear actuators. Channels 3 through 7 are all negative outputs.
Channels Three through Seven (optional) These wires are negative outputs for an optional accessories. Each can be used as either a truncation release, power window up or down, remote starter, control linear actuators or anything else you can imagine. See diagram for installation ideas. NOTES: One additional relay is required to operate each channel. Connecting or activating the additional relays is not required for optimal use.
AMENITY Seven-Channel Shaved Door Handle Kit Wiring Diagram GRAY Channel 1 Driver's Door RED +12 VDC Power Supply Y. BLUE Channel 2 ~ Passenger Door 1 ’ 1 [BLACK Ground -12 VDC << WHITE Channel 3 YELLOW Channel 4 PINK Channel 7 PURPLE Channel 6 BROWN Channel 5 ORANGE ignition 5 Amp 30 Amp RED: +12 battery — + Battery Note: = Additional Relays are NOT included.
Actuator Installation Instructions 1. Attach rod to actuator. 2. Attach rod to door latch or item to be pulled/pushed. 3. Mount actuator to door panel. Remember, if possible, mount the motor vertically to allow for water drainage. Hidden Switch Wiring Diagram Gray Backing Search Hee Backslid ~ Grenadian: Minnie thee Siva OF Switch To Brood Eo mma.
Channels 3 7 Wiring Options Wiring suggestions of the optional negative outputs using a SPIT automotive relay Positive Trigger Channel Three Output 85 Works on trunk/door pops and other +12 VDC systems I~ +12 VDC (Fuse Correctly} | 86 +12 VDC Output to use tress J Negative Trigger Works on trunk/door pops Channel! Three Output 85 mm and other -12 VDC systems Ground 87 30 87A H 86 rrr rr +12 VDC (Use 5 Amp Fuse) «12 VOC Output to use Reverse Trigger For power windows and linear actuators.
Limited Warranty Statement LE. AMENITY LINE WARRANTY STATEMENT LE.l. warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of sale to the original purchase, and not more than two (2) years from the date of manufacture. LE.I. will repair this product free of charge if, in the judgment of LE.L, it has been proven defective within the warranty period.