350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 on the internet: www.ridetech.
Connector # 1 – Power harness •Connect green/black stripe to----------------- illumination •Connect yellow to-------------------------------- ignition •Connect black to----------------------------------directly to ground of battery •Connect red to------------------------------------ directly to battery 12v positive Connector # 2 – Sensor harness •Connect green/white wire to------------------ left front pressure sensor •Connect brown wire to------------------------- right front pressure sensor •Connect purpl
OPTIONAL: If you have the optional remote control system, set the slide switch on the side of the transmitter to the “UP” position and press the #5 button on the side of the keyfob transmitter to enter the #1 setting into the remote control system. The main control panel display will flash slowly four times to indicate remote control setting #1 was successful. After ALL programming is complete, return the DIP switches to the “ON” position to activate the air pressure presets.
To Change ride height with the optional remote transmitters: Remotes only function with ignition OFF 1. To raise vehicle place remote switch in the UP position 2. To lower vehicle place remote switch in the DOWN position 3. Press the corresponding button of the remote for the corner you wish to raise/lower Remote Automatic Height Adjustment via Programmed settings: The remote will only operate when ignition is OFF To return to Setting Number 1: 1. Turn the ignition OFF 2.
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.