FCC ID: KNF6RX FCC Compliance and Advisory Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules.
Installation: 1) Mount the enclosure in a secure location. Select a location that will minimize the amount of wire needed and that is as shielded as possible from the elements. 2) Run a pair of wires (6 awg is recommended) from a 12 Volt battery (do not connect to the battery at this time) to the box and feed them in through one of the black wire glands. 3) Connect your positive battery wire to the “+” terminal on the case. 4) Connect your negative battery wire to the “-” terminal on the case.
Programming/Re-Programming Transmitter: Before you begin, here are some hints: • • • The included keyfobs are pre-programmed from the factory to match the included receiver. Before beginning, gather all of the keyfobs that you wish to program. The receiver will store codes for up to four keyfobs, but all must be programmed at the same time. Programming an additional keyfob at a later date will erase all previously stored keyfob codes.