Operation Manual

SW100 is a reader integrating a qr code scanning, magnetic stripe card technology, contact and
contactless smart card technology and password keyboard, mainly to meet the current card
system in a qr code scanning, magnetic stripe card, contact, contactless IC card needs. The
current interface mode is USB communication, the power supply USES USB port to get electricity,
and USB is equipped with no drive technology. It has 4 SAM sockets. We support the literacy of
social security CARDS, bank CARDS, medical CARDS, transportation CARDS, IC CARDS, electronic
CARDS and other CARDS. SW100 series multifunctional reader is a necessary front-end
processing device for IC card system integration, which greatly improves the security of the
system and the convenience of application. The following part is the test operation manual,
which is divided into four parts: contact function test, non-connection function test, magnetic
stripe function test and scan code function test.
Test tool usage:
1. Click open port; 2. Select the button of the corresponding function to test;
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.