User's Manual

EA-R02 RF Controller Kit
Operating Instructions
J-EA-R02-M_revB Page 1 of 1
Package Contents
• EA-R02-102 Transmitter Keyfob (qty 2)
• EA-R02-202 Receiver Unit
• Wire Harness
Transmitter
Specifications
Receiver Power: 12VDC (±10%)
Receiver Idle Current: 10mA (maximum), no attached devices
Receiver Operating Current: 1A (maximum), no attached devices
Receiver Outputs: three Form C relays, rated 15A at 14VDC
Operating Range: up to 60 feet (open air)
Operating Frequency: 433.92MHz
Coding Type: Fixed Code
Transmitter Power: Type CR2016 3VDC battery (qty 2 per
transmitter)
Normal Use
The keyfob transmitter can be used to lock and unlock the system.
Unlocking the System
Press the transmitter’s UNLOCK button. The transmitter LED will turn on
and the system will unlock and the auxiliary output will pulse twice, as
shown in the figure below:
Locking the System
Press the transmitter’s LOCK button. The transmitter LED will turn on and
the system will lock and the auxiliary output will pulse once, as shown in
the figure below:
Pulsing Auxiliary Output
Press the transmitter’s LOCK and UNLOCK buttons at the same time. The
transmitter LED will turn on and the auxiliary output will pulse five times, as
shown in the figure below:
Transmitter Battery Replacement
Replace the transmitter battery with two Type CR2016 3VDC batteries.
The batteries can be replaced by opening the transmitter enclosure.
Wire Harness Fuse Replacement
Replace with 15A automotive blade fuse only.
Receiver Unit Mounting and Wiring
The receiver should be mounted in a location to minimize RF shielding.
Two mounting screw bosses are provided to mount the receiver.
FUSE
(1)
(2)
(3)
(4)
(5)
(6)
(7)
FUSE
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Wire Wire Color Description
1 Red Power Supply Input (12VDC)
2 Black Ground
3 Black Ground (for use with auxiliary output)
4 Yellow Auxiliary Output
5 Blue Lock Actuator Output (connect to actuator blue
wire)
6 Green Unlock Actuator Output (connect to actuator green
wire)
7 Black Antenna (do not connect)
This device complies with Part 15 of the FCC Rules.Operation is subject to
the following two conditions:
1. this device may not cause harmful interference and
2. this device must accept any interference received, including
interference that may cause undesired operation of the device.
For technical support of this product contact: [e-mail]
or visit: www.southco.com
.