User's Guide

ManualsBrandsSouth Pacific Electronics ManualsElectronics27MHz Handheld Gigalink Transmitter, Model GLT270X

GLT2700/1/2/3/4

27MHz HAND HELD GIGALINK

™

TRANSMITTERS

The hand held GIGALINK



transmitters are the most advanced Remote Control technology available

in the world today. GIGALINK



is an invention that has revolutionised the entire Remote Control

technology including Elsema’s earlier version of FMT- … and FMR- … series. The GLT2701/2/3/4

state-of-the-art invention brings a new dimension in the world of Remote Control technology in

domestic, commercial and industrial applications.

GIGALINK

TYPE: GLT2701

GIGACODE MODULATION

GIGALINK

TYPE: GLT2702

GIGACODE MODULATION

GIGALINK

TYPE: GLT2703

GIGACODE MODULATION

GIGALINK

TYPE: GLT2704

GIGACODE MODULATION

The innovative microcontroller technology replaces the traditional dip switch coding by eliminating

any possible code grabbing. Special features such as over four billion code combinations and the

ability to program any number of transmitters to a receiver adds to the most advanced and secure

Remote Controls available.

Summary of content (7 pages)

PAGE 1
GLT2700/1/2/3/4 27MHz HAND HELD GIGALINK™ TRANSMITTERS The hand held GIGALINK transmitters are the most advanced Remote Control technology available in the world today. GIGALINK is an invention that has revolutionised the entire Remote Control technology including Elsema’s earlier version of FMT- … and FMR- … series. The GLT2701/2/3/4 state-of-the-art invention brings a new dimension in the world of Remote Control technology in domestic, commercial and industrial applications.
PAGE 2
The hand held GIGALINK transmitters have a microcontroller in-built single and channelised code programming system that provides flexibility in programming each channel to different receivers. Each transmitter can store to its EEPROM, up to four random channels allowing the user to program each channel from different single channel receivers. This is achieved when single code programming the transmitter channels from a GLR2701, which is a single channel GIGALINK receiver.
PAGE 3
Continuous or Burst Transmission The hand held transmitters can be purchased with a choice of continuous or burst transmission. Continuous transmission will transmit as long as the channel is activated. Burst transmission will transmit for a predetermined time when a channel is activated. Burst transmission locks on a transmission, which ensures a fail-safe transmission from a short activation of a channel. Burst transmission is also required in certain countries where limited transmission time is allowed.
PAGE 4
REGULATORY COMPIANCE STAEMENTS American Users This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Notice This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 5
TECHNICAL DATA ON GLT2701/2/3/4 POWER SOURCE : 9-Volt Battery (Applied to the battery clip) CURRENT CONSUMPTION : Maximum 45mA at 8VDC supply (Only when transmitting). STANDBY CURRENT : 10 uA (typical) TRANSMISSION MODES CONTINUES : BURST (B version) : Transmits as long as the channel is activated. Minimum transmission time is 640 msec. Transmits one 640 msec burst for each channel activation, even if channel is activated for less than 640msec.
PAGE 6
9 V B atte ry 5V R e gu la to r Vo ltag e S u p e rviso r 2 5V RESET A /D A lgoritham C h an n e l 2 3 6 b it C o d e E nco din g A lgo rith am C ha n n e l 3 3 6 bit C o d e C h an n e l 4 3 6b it C o d e MOD 2 7.19 5M H z C O D E F etch ing A lg o rith am R Ch1 C od ing S o cke t OSC Ch2 Ch3 Ch4 BLOCK DIAGRAM R ed LE D EEPROM C h a n ne l 1 36 b it C o d e 5 V F licke rin g a t 12 .5 H z fo r N o rm al Tra nsm isio n Fla sh in g a t 1 H z fo r L o w B a tte ry (B e lo w 6 .
PAGE 7
DIMEMSIONS FOR CUSTOMISED MEMBRANE AND LABELS G IG A LIN K T M C ase 4 8 .0 2 4 .0 B ack V iew of M em b ran e (G LT2 7 0 1) 1 4 .0 8 .0 G IG A LIN K 1 3 .5 4 3 .0 F ro n t M em bra ne / C u stom er L ab el 2 .7 4 .0 T Y P E : G LT 2701 5 .3 5 .5 (90 d eg . fo ld) 1 .7 1 .8 11 .8 2 2 .0 G IG A C O D E T M M O D U LAT IO N 4 8 .0 S ize , S tyle a n d C o lo ur o f B u tto n 3 1 .0 1 2.5 0 .8 0 8 .0 1 0 .2 1 2 .