Sous Vide Circulator iVide INSTRUCTION MANUAL
INTRODUCTION A + and - adjustment buttons B Working illuminator C ON/OFF buttons D Clamp E Max and Min water level F Stainless steel skirt G Water pump cap
OPERATION WARNING This section explains the potential dangers that may arise when operating the sous vide circulator and notes many important safety precautions. 1 Counter tops such as marble and corian cannot withstand the heat generated by the circulator. Place cooking container different surface to prevent damage. 2 Do not use extension cords. Never operate with a damaged cord or plug. Use properly grounded electrical outlets only. 3 Do not immerse system past the top etch mark of stainless steel skirt.
7.Do not use this appliance for anything other than intended use. (Like laboratory work or heating a hot tub) 8.Firmly lock the product by clamping it on the side of your container . Place the container on an even surface to prevent spills and tipping over. Do not place unit on a stove, or in an oven. 9.Do not use deionized water (DI water). 10.Before plugging into a socket, check whether your voltage corresponds to the rating label of the appliance. 11.Don’t let children use and play with this appliance.
normal operation. 17.This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and it’s cord out of reach of children aged less than 8 years.
-s .21. If the appliance falls down into water tank by careless operation, unplugging it first , then removing it out of the tank ,wipping up the water on the applaince surface ,placing it in airy place.. It would be ok for use after complete dry up. Sous Vide circulators are designed to be used only with water. SETUP (clamp & pot) Sous Vide circulator requires a 6-15L container or p ot. and make sure the container or pot capacity meets the requirement.
3. Time setting. Press the “ ” icon to set the time. You can find the timer blinks. First press the + or – adjust button to set hour, then press “ ” again to set the minute. The timer will countdown when it meets the setting temperature. 4. Press the “ ” icon to confirm the setting and the unit will work. If you want to change the setting, press and hold the“ ” icon for 3 seconds, and then repeat the setting as above.
unlocking symbol and the arrow, rotate the skirt in clockwise direction until you can see the arrow and locking symbol are in the same horizontal position.Be cautious with the stainless steel propeller when it crosses over the hole of the stainless steel skirt. Uninstall the skirt Hold and press the clamp,rotate the skirt in anticlockwise direction to take off the skirt. Be cautious with the stainless steel propeller in case it hits the stainless steel skirt.
CLEANING THE SKIRT To clean the stainless steel skirt and pump cover – place into a dishwasher or wash in the sink with detergent. Trouble Shooting FAQ Noise: Under normal operation the system will hum due to the motor, impeller and cooling fan in operation. Grinding noise: The stainless steel skirt is loose. Push the stainless skirt up into the guide groove and turn to the right until you hear a click. With the skirt secure, the noise will go away.
Gurgling + Woosh noise : The pump is sucking air - add more water. You should also see small bubbles in your tank. Food damage : The pump’s water jet is cracking eggs or damaging fish fillets: Turn the pump outlet to face the container wall; this will greatly temper the flow of the pump output. It is also good practice to bag eggs to prevent them from being “blown” around in certain containers. System will not turn on: Check power plug and breakers.
Sous Vide circulators are calibrated to a scientific platinum primary standard which is far more accurate than store thermometers. Lights in house are slightly flickering when system is on : This is normal as the circulator is modulating power. Error code EE1 will be appeared in below situation with alarm sound: 1. No water in tank 2. Water below minmum level 3.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.