User's Manual

ManualsBrandsSource Electronics ManualsAudio EquipmentBluetooth Audio Speaker

WIRELESS SPEAKER

HR BLUETOOTH SPEAKER

The Bluetooth

word mark and logos are registered trademarks owned by Bluetooth

SIG, Inc. and any use of such marks by The Source (Bell) Electronics Inc. is

under license. Other trademarks and trade names are those of their respective owners.

8092991INSTRUCTION

MANUAL

WHAT’S INCLUDED:

•

Speaker

•

USB-C charging cable

•

3.5mm audio cable

•

Instruction Manual

COMPONENT IDENTIFICATION

Power button

Mode control

Mic hole

4. Play/Pause/mode indicator

5. Volume controls

6. Line in port

Charging indicator

Charging port

PRODUCT OVERVIEW

You can use this item with any compatible, Bluetooth

-enabled device to stream music and

enjoy hands-free calling. Please read this manual first before using.

This speaker has an IPX6 rating: protected against high-pressure water jets from all

directions.

OPERATION

TO DO THIS

Play/pause

Press the

HRbutton to play, press

again to resume.

Next track

Press and hold the + button for 2

seconds.

Previous track

Press and hold the — button for 2

seconds.

Increase volume

Short Press the + button.

Decrease volume Short Press the - button.

Answer/ End the call Press the HR button

Reject the call Press and hold the HR Button for 2

second

TWS Press +and – button at the same times

and hold for 2 seconds

Reset Press + and M button at the same times

and hold for 2 seconds

Mode indicator

Rapidly flashing blue

Pairing mode

Steady blue Paired

Steady red Line in mode

Charge indicator

Steady red Charging

Steady green Fully charged

CHARGING

Use the included charging cable to fully charge the speaker before first use. It will take

approximately 4 hours to fully charge.

•

The red LED will be ON while the speaker is charging

•

The red LED will turn green once charging is complete

Tip: When the battery is low, the speaker will beep every few seconds, please charge the

speaker. If it is not plugged in to charge within approximately 15 minutes, it will turn OFF.

PAIRING

1. Press and hold the button to turn the speaker ON. The blue LED will flash.

2. Turn Bluetooth

ON in your device settings and select “HRSP 5041”.

3. Once paired successfully, the blue LED will be ON and the speaker will chime.

If you fail to pair your device or you want to pair it with a new device, please repeat the

steps outlined above.

NOTE: While in pairing mode, the speaker will beep. If there is no device paired within 10

minutes the speaker will turn OFF. To un-pair, press the button or disconnect in your device

settings.

NOTE: The speaker will automatically pair with previously paired devices provided the

Bluetooth

is ON and within range. The speaker will chime to indicate that it has been

successfully re-paired.

TWS (TRUE WIRELESS STEREO) CONNECTION

Connect two 8092991 speakers for a true wireless stereo experience. To connect:

1. Ensure neither speaker is connected to your device via Bluetooth and turn Bluetooth OFF

on your device.

2. Press and hold the button on both speakers to turn ON. The button on both

speakers will flash.

3. On either of speakers, press and hold “+”and “-” button at the same time for about 2 or 3

seconds until a prompt is heard. Another prompt will be heard in 2 seconds. It represents

TWS connected successfully.

4. Turn Bluetooth® ON in your device settings and select “HRSP 5041” for Bluetooth pairing.

5. When you hear the prompt and both button LED stay ON, Bluetooth connection to your

device is completed successfully.

Note: During your device under BT connection with TWS modes in use, you can press both “M”

and “+” buttons at the same time for 3 seconds to clear all the pairing records.

TECHNICAL SPECIFICATIONS

Output Power: 4W

Carrier Frequency: Bluetooth

Battery Capacity: 3.7V/1400mAh

Charging time: 2-3 hours

Frequency

Response:

90Hz -18kHz

Operation Distance: Up to 10m (33ft.)

TWS Distance: 3.5m (11.5ft.)

Play time: 6 hours

Warranty: One year limited

NOTE: This speaker is in compliance with the specified Bluetooth

version. It does not

guarantee compatibility with all the functions on every Bluetooth

enabled device. Please

check your mobile phone’s user manual for compatibility and functionality.

TROUBLESHOOTING

No Sound:

•

Ensure the speaker is charged and has enough battery power for operation

•

Ensure the speaker is switched ON

•

Ensure Bluetooth

device is ON

•

The volume of the speaker is too low, adjust the volume to an appropriate level

NOTE:

•

If the speaker beeps every few seconds, the battery is low. Please recharge the

speaker.

•

When using the HR Speaker for your Personal computer.

1. Select playback device “HRSP 5041 Stereo” for music listening

2. Select playback device “HRSP 5041 Hands-Free AG Audio” when calling is

coming. check the volume when the call is coming. Also

please test the

speaker levels before using as speaker phone.

FCC Caution:

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment.

Summary of content (2 pages)

PAGE 1
8092991INSTRUCTION MANUAL WIRELESS SPEAKER WHAT’S INCLUDED: • • • • HR BLUETOOTH SPEAKER Speaker USB-C charging cable 3.5mm audio cable Instruction Manual The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those of their respective owners. COMPONENT IDENTIFICATION 1. Power button 2. Mode control 3. Mic hole 4. Play/Pause/mode indicator 5. 6. 7.
PAGE 2
IC: 255A-8092991 FCC ID: ZHW-8092991 THE SOURCE - WARRANTY The Source warrants that this product will be free from defects in materials and workmanship for a period of six (6) months from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.