PN4.320D PN4.520D PN1.450D PN1.
4 Channel PN4.320D & PN4.520D Monoblock PN1.450D & PN1.650D • Full MOSFET PWM Power Supply • SMD Technology on Double Sided PCB • 8ga Power Terminals & 12ga Speaker Outputs • High & Low Level Signal Inputs • Selectable 80Hz 12dB High/Low Pass Filter • 2-Ohm Stereo, 4-Ohm Bridged Stable • Total Harmonic Distortion: 0.5% • Frequency Response: 10-35kHz • Signal-to-Noise Ratio:70dB • Damping Factor: > 250 • Stereo Channel Separation: < 55dB • Input Sensitivity: 200mV-6V • Dimensions: 4.75"w x 1.
Mounting Your Picasso Nano any wood, metal, or carpeted surface. The heatsink can be mounted directly to the chassis of the car, or isolated for best performance. It needs proper ventilation, so avoid mounting the amp under seats, in the engine bay, or any other area that moisture might accumulate. Be sure the mounting screws do not penetrate the fuel tank, vibrations can cause damage. Warning Soundstream highly recommends that an in-line fuse or circuit breaker be installed within 18” of the battery.
High Level input connections The high level inputs are for use with speaker level wiring. Most factory source units do not have RCA outputs. Use this connection if your source unit does not have RCA outputs.
Picasso Nano Pre-Amp Features 1. Remote Level Control Connection Connect the remote level control to this terminal. The remote level control allows adjustment of the subwoofer level from a remote location in the vehicle. 2. Low Pass Crossover Adjust the frequency setting of the low pass crossover. The frequency range is 35Hz-250Hz. Frequencies higher than the setting will be filtered out of the audio signal. 3. Subsonic Crossover Adjust the frequency setting of the subsonic crossover.
Setting the gains: It is a fact that very few people, including professional installers, know how to set gains correctly. Failure to do so yields higher distortion, a higher noise floor which decreases dynamic headroom, less than optimum operating conditions for electronic equipment, and higher failure rate for both the electronic equipment and transducers alike. While most people set this control by ear to how loud they want their music, this is not the intent of this control. The range is from 0.
Investigate the layout of your vehicle before drilling or cutting any holes. Take care when you are working near the gas tank, brake lines, hydraulic lines, and electrical wiring. Do not use the amplifier without securly mounting it, as the amp or vehicle may be damaged in the event of an accident. Do not mount the amplifier where the wire connections are unprotected or are subject to pinching or damage from other vehicle components. The 12V power wire must be fused within 18” of the battery.
LIMITED 90-DAY CONSUMER WARRANTY LIMITED TWO-YEAR CONSUMER WARRANTY WITH PURCHASE AND INSTALLATION BY A SOUNDSTREAM AUTHORIZED DEALER Soundstream promises to the original purchaser, to repair or replace this product with a new or refurbishedunit (at Soundstream’s sole and absolute discretion) should it prove to be defective in workmanship or material under normal use, for a period of *two-years from the date of purchase from the Soundstream authorized dealer, PROVIDED the product was purchased and installed