Instruction Manual

Recommended Installation Instructions

A. Prepping the Surface

After removing interior door panels, you are ready to clean the metal areas that will be insulated. If the metal

has “new” look without imperfections, then take a microfiber cloth and wipe away any dust and

debris. If the metal is showing signs of age like rust, we recommend using Acetone with a breathing mask to

wipe off debris and loose particles. A shop vacuum might be needed to remove loose debris on the floorboard.

B. Installing Panels

Now that you have a clean surface, you are ready to start applying the sheets. We recommend using a roller to

release air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out

to the edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and

inspected before reinstalling the interior.

1) Driver Front Door Panel 3) Passenger Front Door Panel

2) Driver Rear Door Panel 4) Passenger Rear Door Panel

4 Piece Custom Cut PRO KIT

2009-2014

INSTALLATION VIDEO

Scan code for “how to” video!

PAGE 1
2009-2014 4 Piece Custom Cut PRO KIT Recommended Installation Instructions INSTALLATION VIDEO Scan code for “how to” video! A. Prepping the Surface After removing interior door panels, you are ready to clean the metal areas that will be insulated. If the metal has “new” look without imperfections, then take a microfiber cloth and wipe away any dust and debris. If the metal is showing signs of age like rust, we recommend using Acetone with a breathing mask to wipe off debris and loose particles.
PAGE 2
Truck Door Kit Instructions 1. Start by locating the fastening hardware on the door panel, take the appropriate screw driver and remove. 2. Once all the screws are removed you can take off the door panel gently watc!hing that you don't break any of the clips or mounting hardware. 3. Pull the panel away slowly and unplug any electrical connections.
PAGE 3
4. Now you are ready to prep the metal surface using a microfiber cloth, Acetone (use a breathing mask), and wipe away any moisture, oil, debris or etc. Then let air dry for an appropriate time. The point is to get the surface clean to ensure material glue contact. 5. When the surface is dry and clean, locate the piece of the kit with the label on the back that coincides with the door you're working on. Make sure it lines up and is correct before you pull the white cover paper off.