Operation Manual

DAB500 / English Instruction Manual

Front view

Side view

Rear view

1. SPEAKER

2. STANDBY BUTTON

3. TUN/CH  BUTTON

4. LCD DISPLAY

5. VOL+ BUTTON

6. MENU/INFO BUTTON

7. PRESET BUTTON

8. SELECT BUTTON

9. TUN/CH  BUTTON

10. MODE BUTTON

11. VOL- BUTTON

12. HEADPHONE JACK

13. DC INPUT SOCKET

14. ANTENNA

15. BATTERY DOOR

SWITCHING YOUR RADIO ON FOR THE FIRST TIME

AC Operation

1. Insert the DC power jack of AC/DC adaptor to the DC input socket located at the right of the

radio.

2. Plug the AC/DC Adaptor to the AC mains outlet.

3. Press the STANDBY to turn the radio on.

Remarks: If the AC Adaptor voltage is over than 6V, it will possible make the line damage.

DC (battery) operation

1. Ensure the AC/DC adaptor is disconnected from the radio and AC mains.

2. Installed the batteries (4×1.5V UM3/AA battery) into the battery compartment.

3. Press the STANDBY to turn the radio on.

Remarks: To obtain the best performance in DC operation, the use of alkaline batteries is highly

recommended.

Display backlight

When the radio is in AC mode, the display backlight will be full brightness all the time.

When the radio is in DC battery operation, the display backlight will be turned on to full

brightness for around 10 seconds and then go to dim, it will then be turned on to full brightness

again for 10 seconds on every key press. In STANDY mode, the radio and display backlight will

be turn off.

PAGE 1
DAB500 / English Instruction Manual Front view 1. 2. 3. 4. 5. 6. SPEAKER STANDBY BUTTON TUN/CH BUTTON LCD DISPLAY VOL+ BUTTON MENU/INFO BUTTON Side view 7. PRESET BUTTON 8. SELECT BUTTON 9. TUN/CH BUTTON 10. MODE BUTTON 11. VOL- BUTTON Rear view 12. HEADPHONE JACK 13. DC INPUT SOCKET 14. ANTENNA 15. BATTERY DOOR SWITCHING YOUR RADIO ON FOR THE FIRST TIME AC Operation 1. Insert the DC power jack of AC/DC adaptor to the DC input socket located at the right of the radio. 2.
PAGE 2
DAB500 / English Instruction Manual DAB mode Press the STANDY button to turn the unit on, it will automatically enter into the DAB mode and perform auto scan function, During the scan the display show “Scanning…” together with a slide bar that indicates the progress of the scan and the amount of stations that have been found so far.(F.1) (F.2) Once the scan has finished, the radio will select the first alphanumerically found station.