JCV1640BT AM/FM/RBDS/WB/USB/AUX-IN/BT/iPod Ready/Sirius XM Ready Heavy Duty Radio Installation and Operation Manual iPhone, iPod, iPod Classic, iPod Nano, iPod Shuffle, and iPod Touch are trademarks of Apple Inc., registered in the U.S. and other countries.
JCV1640BT CONTENTS Introduction............................................................................................................................... 1 Safety Information .................................................................................................................... 2 Installation ................................................................................................................................ 3 Wiring .............................................................
JCV1640BT INTRODUCTION System Features Content List Features of Jensen JCV1640BT mobile audio system include: Full Dot Matrix LCD AM/FM US/EURO Tuner with 30 Presets (12AM, 18FM) RBDS (Radio Broadcast Data Service) with PTY Search Sirius XM Radio Ready USB Playback of MP3 and WMA files iPod Ready (USB Interface) Weatherband Tuner with SAME Technology Mute Bluetooth (Supports A2DP, AVRCP and HFP) Pre-set Equalizer – 5 settings (User, Flat, Pop, Classical, Rock) Electronic Bass, Trebl
JCV1640BT SAFETY INFORMATION When Driving Keep the volume level low enough to be aware of the road and traffic conditions. When Washing Your Vehicle Do not expose the product to water of excessive moisture. Moisture can cause electrical shorts, fire or other damage. When Parked Parking in direct sunlight can produce very high temperatures inside your vehicle. Give the interior a chance to cool down before starting playback.
JCV1640BT INSTALLATION 4. This unit is designed for installation in vehicle cabs with an existing 1-DIN radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. See the dealer where the radio was purchased for kit availability. Always check the kit application before purchasing to make sure the kit works with your vehicle. 5. 6. Before you Begin 1. 2. Disconnect Battery Before you begin, always disconnect the battery negative terminal.
JCV1640BT WIRING DETAIL A SHOWN FROM PIN VIEW PIN NO.
JCV1640BT BASIC OPERATION Mute Press the MUTE button (22) to mute the audio output. Press MUTE again to restore the audio output to the previous level. Mode Press the MODE button (4) to select a different mode of operation, as indicated on the display panel. Available modes include the following: Tuner (AM/FM) > SXM (SiriusXM) > iPod/USB > Auxiliary > BT Audio. Tuner is the default source when a prior source is no longer available.
JCV1640BT System Menu 1. Press and hold the PTY/CAT/MENU button (2) for more than 2 seconds to enter the system menu. The first menu item, “Key Beep”, will appear on the display. 2. Press the TUNE/SEEK |<< / >>| (18, 19) button repeatedly to navigate the system menu. 3. Press the INFO/ENTER button (16) to select the desired item. 4. Press the INFO/ENTER button again to adjust the selected menu item.
JCV1640BT Liquid Crystal Display (LCD) The current frequency and activated functions are shown on the LCD panel (20). NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the characters on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range.
JCV1640BT TUNER OPERATION Automatically Store / Preset Scan (AS/PS) Automatically Store Select an AM or FM band. Press and hold the AS/PS button (14) for more than 2 seconds to automatically select 18 strong stations (12 for AM). “Storing Presets” appears on the screen and the new stations replace any stations already stored. Preset Scan Select a band. Press AS/PS (14) to scan stations stored in the current band. The unit will pause for 5 seconds at each preset station.
JCV1640BT surrounding conditions, weather, obstructions of the signal by hills or mountains, etc. Weather Band Operation NOAA Weather Alert What is the NOAA Weather Radio/Weatheradio Canada? The Weather Alert function adds an additional level of user safety by automatically switching from any of the available function modes to weather band for a minimum of 60 seconds if a NOAA warning tone (1050 Hz) is received/detected.
JCV1640BT Random Play Press the 3/RDM button (5) during playback to play all tracks in the current folder in random, shuffled order. Press 3/RDM again to stop random play. Folder Navigation (MP3 Only) Press the PTY/CAT/MENU button (2) to view a list of all songs in the current folder. Press the >>| / UP (19) and |<< / DN (18) buttons to navigate the list. Press the INFO/ENTER button (16) to play the highlighted song or view files in the selected folder.
JCV1640BT SATELLITE RADIO OPERATION 4. channel tuned.) Press the INFO/ENTER button (16) to select the desired channel. Channel Up/Down Tuning Press the TUNE/SEEK |<< / >>| buttons (18, 19) to search for a channel. Press and hold the TUNE/SEEK buttons to fast search. Direct Tuning Mode 1. 2. 3. 4. 5. 6. 7. NOTE: SiriusXM is available in the US for subscribers with addresses in the continental US and is available in Canada for subscribers with a Canadian address.
JCV1640BT Satellite Signal Strength Reset SiriusXM Channel Lock Code The display will indicate satellite reception strength as shown below. If you forget your Parental Control lock code, use the following directions to reset the code to the default “0000”. Resetting the lock code will not affect the locked channels list. 1. In SiriusXM mode, tune to Channel 0 2. Set volume to 0. 3. Press and hold the volume knob to power off the unit. 4.
JCV1640BT Advisory Messages Reported by the SiriusXM Vehicle Tuner On-Screen Display Check Antenna Advisory Message Check Antenna Cause Explanation/Solution The radio has detected a fault with the SiriusXM antenna. The antenna cable is either disconnected or damaged. Verify that the antenna cable is connected to the SiriusXM Connect Vehicle Tuner. Inspect the antenna cable for damage and kinks. Replace the antenna if the cable is damaged.
JCV1640BT On-Screen Display Advisory Message Cause Explanation/Solution Chan Locked Channel Locked The channel that you have requested is Locked by the radio Parental Control feature. See the section on Parental Control, page 12 for more information on the Parental Control feature and how to access locked channels. Enter Code: _ _ _ _ Enter Lock Code User prompted to enter the lock/unlock code.
JCV1640BT iPod OPERATION Controlling Playback Pausing Playback During playback, press the MUTE/>|| button (22) to pause the iPod player. “Pause” will appear on the LCD. Press MUTE/>|| again to resume playback. Repeat Play During playback, press the 1/RPT button (8) to repeat the current song. “RPT” will appear on the LCD. Press 1/RPT again to stop repeat playback. Random Play During playback, press the 3/RDM button (5) to play all songs in the current category in random order.
JCV1640BT BLUETOOTH OPERATION The JCV1640BT includes built-in Bluetooth technology that allows you to connect this head unit to Bluetooth devices for streaming audio playback. BT Device Press Enter Use SEEK +/to Navigate the List Press Enter Device 1 Device 2 Device 3 Device 4 Device 5 About Bluetooth Technology Bluetooth is a short-range wireless radio connectivity technology developed as a cable replacement for various electronic devices. Bluetooth operates in 2.
JCV1640BT Selecting Tracks During playback, press the SEEK/TUNE buttons (18, 19) to play the previous or next track. Pausing Playback During playback, press the MUTE/>|| button (22) to pause the Bluetooth AUDIO player. “BT AUDIO PAUSE” will appear on the LCD. Press MUTE/>|| again to resume playback. If you change to another mode, the mobile phone audio will pause. Press the MODE button (4) to return to Bluetooth mode and resume mobile phone audio playback.
JCV1640BT CARE AND MAINTENANCE TROUBLESHOOTING Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. Keep the product away from dust and dirt, which can cause premature wear of parts. Handle the product gently and carefully. Dropping it can damage circuit boards and cases, and can cause the product to work improperly. Wipe the product with a dampened cloth occasionally to keep it looking new.
JCV1640BT SPECIFICATIONS USB Signal to Noise Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 65 dB Channel Separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . More than 50 dB Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz - 20 kHz FM Radio Frequency Coverage (USA) . . . . . . . . . . . . . . . . . . . . . . .
ASA Electronics Corporation www.asaelectronics.com www.jensenheavyduty.com ©2014 ASA Electronics Corporation v.