FCC ID: HEPTAGONS INSTRUCTION TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
e+TAG™ ET-RS / ET-TS Installation Instructions INSTALLATION STEPS: 1. 2. 3 Drill holes as needed per installation diagram shown below. Feed cable through 3/4” hole. Attach the mounting plate to the mounting surface with the appropriate fasteners. Attach the housing to the mounting plate by inserting the two tabs inside the top of the housing into the two slots at the top of the mounting plate. Secure by installing supplied screws into the hole at the bottom of the reader.
e*TAG™ ETAS Installation Instructions INSTALLATION STEPS: 1. Drill holes as needed per installation diagram Reader Hosea ee Raa sing Mes shown below. 2. Feed cable through 3/4" hole. Attach the mounting plate to the mounting surface with the appropriate fasteners. 8 g 4. Attach the housing to the mounting plate by inserting the two tabs inside the top of the | — housing into the two slots at the top of the 1 1 mounting plate.