Owner's Manual

SWITCHPLATE INSTALLATION DIAGRAM
Mounting Plate
Reader
Housing
Mounting
Surface
¿
¿
Use appropriate
Fastener
¿
Use supplied
screw
¿
3/4” diameter
through hole
for cables.
¿
¿
¿
3.28
3322252 7472
1. If mounting the unit outdoors, especially on a
rough surface like masonry, we recommend
that you seal the reader with silicone
caulking.
2. Drill holes as needed per installation diagram
shown to the left or install a single gang j-box.
3. Run eld wiring to reader location and feed
into j-box or through cable hole.
4. Attach the mounting plate to the mounting
surface or j-box with the appropriate
fasteners.
5. Splice the connector pigtail to eld wiring. Insert
the connector into the back of the reader.
6. Attach the housing to the mounting plate by inserting the two tabs
inside the top of the housing into the two slots at the top of the
mounting plate.
7. Secure by installing supplied screw into the hole at the bottom of the
reader.
INSTALLATION STEPS FOR RKDT-SA-S/PPLX:
¿
3.20
4.50
¿
¿
¿
RKDT-PPLX Family Installation Instructions
1. If mounting the unit outdoors, especially
on a rough surface like masonry, we
recommend that you seal the reader with
silicone caulking.
2. Drill a hole for the eld wiring. Remove
decorative cover from reader. Using the
reader as a template, mark the location
of the two mounting holes. Drill two 1/8”
pilot holes for the mounting screws.
3. Run eld wiring to reader location and
feed through cable hole.
4. Splice the connector pigtail to eld wiring.
Insert the connector into the back of the reader.
5. Attach the reader to the surface using the two machine screws
provided. These may be replaced with tamper proof screws
(customer supplied).
6. Slip on the decorative cover (if used) until both tabs snap into
place.
MULLION INSTALLATION DIAGRAM
4.38”
1.74”
3.14”
.90”
4.38”
1.74”
3.14”
.90”
Use supplied screws
1/2” Diameter hole in
mounting surface for
wiring
l
Mounting
Surface
l
INSTALLATION STEPS FOR RKDT-SA-M
20301 Nordhoff Street, Chatsworth, CA 91311
PHONE [phone] • FAX [phone]
TOLL-FREE [phone]
Website: www.securakey.com • E-mail: [e-mail]
1. Drill holes as needed per installation diagram shown to
the left.
2. Feed cable through 3/4” hole.
3. Attach reader to any at surface
with two #6 screws.
4. Snap label insert into front of
reader to cover screws.
3.50
1.60
Label Tabs
Insert Here
LED
¿
¿
¿
¿
¿
¿
MULLION INSTALLATION DIAGRAM
1.0”
l
l
l
l
1.3”
Use appropriate
#6 Fastener
3/4” Diameter through
hole for cable and
buzzer.
l
l
INSTALLATION STEPS FOR RKDT-WM