USER MANUAL SOUNDCAST WIRELESS AUDIO SYSTEMS KSC INDUSTRIES, INC.
TABLE OF CONTENT 1. GENERAL DESCRIPTION........................................................................................... 2 2. FEATURES .................................................................................................................... 4 3. ELECTRICAL SPECIFICATIONS ............................................................................... 5 3.1 OPERATING CONDITIONS – SOUNDCAST G2 TRANSMITTER.................................. 5 3.
1. General Description SoundCast is a complete point-to-point and point-to-multipoint wireless audio solution. SoundCast digitizes a 2-channel stereo input signal, sends it across a robust radio frequency link, and then converts it back to a stereo analog signal for use at a remote location. SoundCast is ideal for home theater rear speakers, headphones, public address systems, and outdoor speakers. SoundCast wireless audio product family has two members.
Figure 2, SoundCast G2-ER system block diagram 3
2. Features v v v v v v v v v v v v v v Stereo Analog In/Analog Out, Digital In/Digital Out; 92.4 dB SNR, 0.065% THD+N; Digital volume control; Auto Mute; Digital Noise Gate; 2.4 GHz wireless link, 1.
3. Electrical Specifications 3.1 Operating Conditions – SoundCast G2 Transmitter Note: All Min/Max characteristics and specifications are guaranteed over the Specified operating conditions. Typical performance characteristics and specifications are derived from measurements taken at typical supply voltages and TA=25oC. 3.
3.3 Operating Conditions – SoundCast G2 Receiver 3.
3.5 Operating Conditions – SoundCast G2-ER Transmitter 3.
3.
3.
4. Audio Characteristics This table describes the audio characteristics of SoundCast (5.0V supply applied to the DAC on the SoundCast G2 Receiver). Note: 1. All measurements are for 5 bit HFADPCM encoding. 2. Relative to Full Scale Output at RX Line Out, Left Channel. 3. RX Line Out into a 10 k? load.
5. RF Characteristics The SoundCast RF algorithm is described below paying special attention to include information pertinent to FCC and ETSI regulations. The SoundCast software operates by selecting a palette (or group) of 15 random channels out of the total 38 to hop on. For the 15-channel palette, any channels with poor transmission rates are replaced with better channels from the remaining 23 unused channels. The hopping pattern from channel to channel is a random pattern.
12
5.1 RF Characteristics - SoundCast G2 Transmitter and Receiver 5.
6. Pin Description 6.
6.
7. Information to User This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.
least 20 cm must be maintained between the unit's antenna and the body of the user and any nearby persons at all times and in all applications and uses.