Important Safety Instructions READ BEFORE INSTALLING BEFORE YOU BEING Please verify the following items: Ensure your TV and any other accessories you plan to use DO NOT EXCEED the specified weight limit of your TV wall mount. You read and understand these directions. You refer to the documentation that came with your Sonos® Beam™ and TV wall mount for additional guidance. You have the tools needed for installation.
/\ WARNING This Sonos® Beam™ TV Attachment is only designed to be used with TV wall mounts that meet third party safety certifications. This Sonos® Beam™ mount is only designed to mount the soundbar BELOW the television. This soundbar mount is designed to be installed and utilized only as specified in this manual. The manufacturer is not responsible for improper assembly, use, or handling of this product.
SAFETY WARNING WEIGHT RESTRICTIONS A CAUTION: Avoid potential personal injuries and property damage! The weight of your TV + TV Mounting Bracket + Sonos® Beam™, and any accessories, MUST BE LOWER than the maximum weight rating of your TV mount. See your TV mount's manual for maximum weight allowed. a Mount Weight Beam™ Weight 3.52 Ibs (1.6 kg) 6.2 Ibs (2.
REQUIRED FOR FITTING PARTS SUPPLIED 3rd Party Certified TV Wall Mount * Phillips Screwdriver Mount Spacer =r Sonos® Beam™ *Your TV wall mount may vary from the illustrations throughout this manual — NOTE that the procedure iP T to install the Sonos® Beam™ is the same.
Prepare Your TV (if mounted) your TV is already mounted: A IMPORTANT: Follow your TV mount’s manual for instructions on how to safely remove your TV and TV bracket. Remove any cables attached to your TV. Remove your TV / bracket assembly from your wall plate, arm assembly, or pillar. tl HEAVY: You WILL need assistance with this step! Remove the TV bracket(s) and hardware from your TV.
Determine which screw diameter fits your monitor For TVs with a flat unobstructed back follow step 2.1 For TVs with a rounded / irregular obstructed back, follow step 2.2 If you need extra space to accommodate cables, recesses or protrusions, follow 2.2 Standard configurations shown. For special applications, contact Customer Service. Steppe Steppe CAUTION Ensure adequate thread engagement with your screw/washer/spacer combination AND all brackets. 4+ TOO SHORT will not hold the TV.
Fixing Sonos® Beam™ Attachment to TV Prepare the Soundbass® TV Attachment Loosely fix the ARMS [HE of the Sonos® Beam™ Attachment together with the bracket using the 4 x M5 nuts [TJ use spanner Attaching to the TV Install your TV mount's interface bracket with the Sonos® Beam™ Attachment assembly using mount spacers Fill on the TV's top two holes (If required). [EF NOTE: Soundbar mount ARMS [EH and mount spacers Xl fit BETWEEN your TV and TV mounting bracket.
Fixing Sonos® Beam™ Attachment to TV Prepare the Soundbass® TV Attachment 2x Mount Spacer. Loosely fix the ARMS [of the Sonos® Beam™ OG Attachment together with the bracket [CH using the 4 x M5 nuts [lf use spanner [H] REMEMBER #7 Attaching to the TV : Perfect Install your TV mount’s interface bracket with : Engagement the Sonos® Beam™ Attachment assembly using mount cyberspace on the TV's top two holes and TV spacers EX] (If required).
Adjusting the Sonos® Beam™ Attachment Adjust both arms of the Sonos® Beam™ TV Attachment so the speaker is in the desired potion. NOTE: You may need to reposition the hole locations on the arms to adjust the Beam™ to your desired position. IMPORTANT: The final position of your Beam™ must be within 2 inch (51mm) of the bottom of the TV. NOTE: When positioning your Beam™, make sure you will be able to access the control buttons on the top surface.
Tightening Hardware Once your Sonos® Beam™ Attachment is in the desired position tighten ALL the screws and nuts to fix the mount in position IMPORTANT: We recommend that you remove the Beam™ now before rehanging the TV to the wall A IMPORTANT! Do not over-tighten the screws this will deform the washers.
Sw UND B AS SB Thank you for buying the Soundbass® TV Mounting Attachment for The Sonos® Beam™ N= nil = Sound bass® is a register trademark all right reserved Sonos® & Beam™ are trademarks of Sonos®, Inc. Soundbass® is NOT affiliated with Sonos®, Inc.
Re-Hanging Your TV with Sonos® Beam™ ud HEAVY: You will need assistance with this step! Follow your TV wall mount installation manual to hang your TV assembly.