User Manual

LZT 123 4598/23 PA1
Important Information
THIS PHONE MODEL HAS BEEN CERTIFIED IN COMPLIANCE
WITH THE GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
This mobile phone model T206 has been designed to comply with
applicable safety requirements for exposure to radio waves. Your wireless
phone is a radio transmitter and receiver. It is designed to not exceed the
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission (FCC) of the U.S. Government. These
limits establish permitted levels of RF energy for the general population.
The guidelines are based on standards that were developed by
international scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a safety margin
designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be well below
the maximum value. This is because the phone is designed to operate at
multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna,
the lower the power output. Before a phone model is available for sale to
the public, it must be tested and certified to the FCC that it does not
exceed the limit established by the government-adopted requirement for
safe exposure. The tests are performed in positions and locations (i.e., at
the ear and worn on the body) as required by the FCC for each model.
The highest SAR value as reported to the FCC for this model phone when
tested for use at the ear is 1.48 W/kg and when worn on the body is 1.27
W/kg. Body worn measurements are made while the phone is in use and
worn on the body with an Ericsson or Sony Ericsson accessory. Accessories
can significantly affect SAR compliance. The Federal Communication
Commission requires that some manufacturers' accessories be tested, and
Sony Ericsson has done so with respect to its products. Sony Ericsson has
only tested Ericsson and Sony Ericsson original accessories in conjunction
with Sony Ericsson phones. It is therefore recommended that only
Ericsson and Sony Ericsson original accessories be used in conjunction
with Sony Ericsson phones. The FCC has granted an Equipment
Authorization for this model phone with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. While there may
be differences between the SAR levels of various phones, all mobile
phones granted an FCC equipment authorization meet the government
requirement for safe exposure.
SAR information on this model phone is on file with the FCC and can be
found under the Display Grant section of http://www.fcc.gov/oet/fccid
after searching on FCC ID PXITR-503-A2. Additional information on
Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications & Internet Association (CTIA) web-site at http://
phonefacts.net/.
* In the United States and Canada, the SAR limit for mobile phones
used by the public is 1.6 watts/kilogram (W/kg) averaged over one
gram of tissue. The standard incorporates a margin of safety to give
additional protection for the public and to account for any variations in
measurements.