November 21, 2019 2082 - Alpha LED Pendant proton ™ assembly instructions 1 of 8 Multiple U.S. and foreign patents pending.
November 21, 2019 Proton™ Product Information and Warnings Important • Always disconnect the power before installing or replacing Luminaires and before cleaning or other maintenance. • Consult a qualified, licensed electrician to ensure correct branch circuit conductor. Consulter un électricien qualifié pour vous assurer que les conducteurs de la dérivation sont adéquats. • Please read all included assembly instructions and warnings carefully before installation.
November 21, 2019 Welcome to Proton™ A Proton configuration is built from LED luminaires, connecting hubs, connecting arms, and an arm splitter. Illumination radiates from the glass globes. The connecting arms form a structural and electrical connection between the hubs, and are easily assembled by inserting the arm into the hub and are secured in place by a retaining set screw.
November 21, 2019 Proton Alpha Pendant Assembly Step 1 - Assemble Frame a. Fully insert the C3 Arms into the 'A' ports in the three Connectors (Fig. 2). Fig 3 shows the different ports on the connector. b. After each Arm is inserted, install the M2 Set Screws into the Ports of the Connectors, using the Small Hex Wrench provided, and tighten until they come in contact with the plastic caps on the Arms. c. Make sure that the 'C' ports are facing outwards. Completed step shown in Fig. 4.
November 21, 2019 POWER SUPPLY AND POWER FEED INSTALLATION Important • Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance. • Consult a qualified, licensed electrician to ensure correct branch circuit conductor. Consulter un électricien qualifié pour vous assurer que les conducteurs de la dérivation sont adéquats. Step 2 - Electrical Installation a. Shut off power to the outlet box (A). b. Feed the cords through the bushings (H).
November 21, 2019 Proton Single Pendant Assembly Step 2 - Attach Lower Arms a. Insert the C2 Arms into the Arm Splitter about halfway. b. Slide those into the 'B' ports of the Connector until it reaches the end, then screw it in until tightened as shown in Fig. 5 & 6. This may require small adjustments to each arm until all are secure. Arm Splitter Fig. 6 C2 Fig.
November 21, 2019 Proton Single Pendant Assembly Step 3 - Attach Remaining Arms a. Slide the C1 arms into the 'C' ports of the Connector until it reaches the end, then screw it in until tightened as shown in Fig. 7 & 8. b. Restore power to outlet box. Fig. 8 C1 7 of 8 Fig.
November 21, 2019 COMPLETED ASSEMBLY 8 of 8 ©2019 SONNEMAN - A Way of Light
November 21, 2019 Coax Splicing Assembly Instructions INSTRUCTIONS D’INSTALLATION FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID THE WARRANTY Coaxial Power Cord: Outer Braided Conductor Inner Stranded Conductor End View Insulation Outer Jacket If field-cutting is required, please follow the below instructions: 1. Make a 1” slice along the length of the cord's outer jacket (Fig. 1). CAUTION: Do not cut through the outer braided conductor. 2.
