Full-motion Wall Mount MD111124-01 AWM2301
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, telephone your local distributor for a replacement. WARNING • Do not begin the installation until you have read and understood the instructions and warnings contained in this installation sheet.
1. Removing the Decorative Covers 2b. Solid Brick and Concrete Block Mounting: 60mm/2.4" ø 10mm ø 3/8" 1 2a. Wood Stud Wall Mounting: 2 55mm/2.2" ø 4.5mm ø 3/16" Drill pilot holes 1 2 W-B W-C W-A √ X X 3 Drill pilot holes W-C W-A √ X X Screw the wall mount onto the wall with the up arrow of the plate upward Screw the wall mount onto the wall with the up arrow of the plate upward WARNING • Make sure that mounting screws are anchored into the center of the studs.
3. Installing Decorative Covers 5. Installing Adapter Bracket 5-1 For Flat Back Screen TV M-A M-C M-E M-G TV TV M-I 4. Removing the lower thumbscrew. Tighten all screws but do not over tighten.
-2 For Recessed Back Screen or to Access A/V Inputs TV TV TV M-I 6. Hook the TV onto the Wall Mount M-B M-D M-F Two qualified persons are required 4mm M-J Loosen the upper thumbscrew spacing 4mm to adapter bracket. Hook the TV onto the wall mount or M-H M-I M-K · Position the adapter bracket as close as possible to the middle of the screen. · Screw the adapter bracket onto the TV. Tighten all screws but do not over tighten. -7- · Position the TV level.
8. Adjusting Wall Mount Head 7. Cable Management M-L Depending on the weight of the display, it is necessary to slightly loosen or tighten the adjustment screw using a 4mm Allen key. 9. Pitching Angle Adjustment +3° 180° -3° 180° +15° -15° • Remove cable covers as required, Connect cables to your TV and route along the arms. • Re-attach the cable covers to hold the cables in place . Adjust to desired location or tilt Note: Leave slack in cables to allow for cantilever arm movement.