User's Manual

ManualsBrandsSonicwall ManualsElectronicsSonicPoint

Page 1

SonicWALL SonicPoint - Model APL13-02C

FCC Part 15 Class A Notice

NOTE: This equipment was tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy. And if

not installed and used in accordance with the instruction manual, the device may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user is required to correct the interference at

his own expense.

Complies with EN 55022 Class A and CISPR22 Class A.

*Refer to the label on the bottom of the unit for device information including Class A or Class

B FCC information.

Caution: Modifying this equipment or using this equipment for purposes not shown in this

manual without the written consent of SonicWALL, Inc. could void the user’s authority to

operate this equipment.

BSMI Statement

VCCI Statement

Summary of content (9 pages)

PAGE 1
SonicWALL SonicPoint - Model APL13-02C FCC Part 15 Class A Notice NOTE: This equipment was tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy.
PAGE 2
Canadian Radio Frequency Emissions Statement This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à toutes la norme NMB-003 du Canada. CISPR 22 (En 55022) Class A Warning: This is a class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
PAGE 5
Wall Mounting the SonicWALL SonicPoint Follow the instructions below to mount the SonicPoint on the wall. 1. Using the mounting plate as a template, mark the places to insert the mounting anchors. 2. Using a #2 Phillips screw driver, press the tip of the anchor into the marked places on the hollow wall. 3. Turn the screwdriver clockwise until the anchor is flush with the wall. Repeat for the second anchor. 4.
PAGE 6
. Slide the plate down to the narrowest part of the keyhole so that the mounting plate rests on the screws. 7. Tighten the mounting screws to secure the mounting plate. 8. Snap the SonicPoint onto the mounting plate.
PAGE 7
Mounting the SonicWALL SonicPoint on the Ceiling 1. Locate a metal support to hang the SonicPoint. 2. Using the mounting plate as a template, mark the places to insert the mounting anchors. 3. Drill two holes for #6 x 1-1/4” screws in the marked location. 4. Install the #6 x 1-1/4” self-tapping screws leaving a slight gap for the mounting plate. 5. Hang the mounting plate on the screws. 6. Slide the plate down to the narrowest part of the keyhole so that the mounting plate rests on the screws. 7.
PAGE 8
. Snap the SonicPoint onto the mounting plate. Other Considerations for Mounting the SonicWALL SonicPoint • • • • Page 6 Mount in a location away from direct sunlight and sources of heat. A maximum ambient temperature of 104º F (40º C) is recommended. Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios, transmitters, and broadband amplifiers Ensure that no water or excessive moisture can enter the unit.
PAGE 9
SonicWALL, Inc. 1143 Borregas Drive Sunnyvale, CA 94089 Tel: (408) 745-9600 Fax: (408) 745-9300 E-mail: info@sonicwall.com Web: www.sonicwall.com P/N 232-000512-00 Rev A.