Installation Guide

ManualsBrandsSonic Innovations ManualsElectronicsHearing Aid

Sonic Radio Model - Quick Installation Guide

Radio Model Name: mini RITE Fusion 2

Sonic Innovations, Inc. 2501 Cottontail Lane – Somerset, NJ 08873 – United States of America Page 1

Main +1 888 423 7834 www.sonici.com

The mini RITE Fusion 2 radio model is a low

power, inductive radio transceiver working at 3.84

MHz consisting of:

 a Digital-Signal-Processor (DSP)

 a radio Front-End (FE)

 memory (EEPROM)

 antenna coil

 and smaller components

All components are mounted on a flexible Printed-

Circuit-Board (PCB), which is intended to be

installed as a module into Sonic wireless hearing

aid devices.

The module also has all voltage regulators

included inside the DSP and FE and buffered data

programming inputs on the board.

The module requires a battery, one or two

microphones and an audio receiver to be attached

and must be mounted in an external plastic shell.

The module is depicted to the right with its main

components and connections:

Summary of content (4 pages)

PAGE 1
Sonic Radio Model - Quick Installation Guide Radio Model Name: mini RITE Fusion 2 The mini RITE Fusion 2 radio model is a low power, inductive radio transceiver working at 3.84 MHz consisting of:      a Digital-Signal-Processor (DSP) a radio Front-End (FE) memory (EEPROM) antenna coil and smaller components All components are mounted on a flexible PrintedCircuit-Board (PCB), which is intended to be installed as a module into Sonic wireless hearing aid devices.
PAGE 2
Sonic Radio Model - Quick Installation Guide Radio Model Name: mini RITE Fusion 2 1. End product labelling requirements For an end product using the module “mini RITE Fusion 2”, there MUST be a label containing, at least, the following information: This device contains FCC ID: ZTOF2RITE3 IC: 9799A-F2RITE3 The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection in compliance with the modular approval guidelines developed by the FCC.
PAGE 3
Sonic Radio Model - Quick Installation Guide Radio Model Name: mini RITE Fusion 2 When the device is so small or for such use that it is not practicable to place the statement above on it, the information shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user or, alternatively, shall be placed on the container in which the device is marketed. However, the FCC ID label must be displayed on the device.
PAGE 4
Sonic Radio Model - Quick Installation Guide Radio Model Name: mini RITE Fusion 2 3. Caution Any changes or modifications NOT explicitly APPROVED by Sonic Innovations, inc. may void the FCC / IC authorization to operate this equipment. 4. RF-exposure statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.