Installation Instructions

SONANCE LANDSCAPE SERIES
19” GROUND POST
FOR LS68SAT
INSTALLATION INSTRUCTIONS
READ THESE INSTRUCTIONS CAREFULLY
BEFORE INSTALLING THIS POST
This post is intended for installation in accordance with the National
Electrical Code and local code specifications. Failure to adhere to
these codes and instructions may result in serious injury and/or
damage to the post and will void the warranty. These instructions
cover most installation applications. For any special applications not
covered, please contact Sonance for assistance.
INSTALLATION INSTRUCTIONS
1. Excavate for the conduit runs and the Perma-post.
2. Install the conduit.
3. Slide the stabilizer grid onto the PVC pipe as shown in the
illustration and secure with the two short screws supplied.
Discard the long screw.
4. Place the post over the conduit and speaker supply wires as
shown in the illustration.
5. Backfill against mounting post.
6. Install the speaker onto the cap.
7. Pull the speaker supply wires through the conduit.*
*Conduit is not always required.
8. Connect supply wires to satellite speaker wires with wire nuts.
9. Install the fixture and cap onto the top of the post and tighten
the set screw.
33-7439 05.25.17
SATELLITE
SPEAKER
SET
SCREW
PERMA-POST
CAP
STABILIZER
GRID
CONDUIT
SPEAKER WIRES
PVC PIPE
SUPPLY WIRES
GROUND LEVEL
©2015 Sonance. All rights reserved. Sonance is a registered trademark of Dana Innovations.
Due to continuous product improvement, all features and specifications are subject to change without notice.
For the latest Sonance product specification information visit our website: www.sonance.com
SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA
[phone] • FAX: [phone] • Technical Support: [phone]
www.sonance.com