IN-GROUND SUBWOOFER INSTRUCTION MANUAL LS12T SUB | LS15T SUB
Introduction Thank you for purchasing a SLS Subwoofer. When properly installed, this subwoofer will provide you with years of outdoor entertainment pleasure. To get the most out of your new subwoofer, please read this manual thoroughly before you begin installation.
Subwoofer Installation NOTE: THE SUBWOOFER IS VERY HEAVY, ALWAYS TEAM LIFT. DO NOT HOLD BY SPEAKER WIRE OR PLASTIC STRAIN RELIEF. Sonance Landscape Series systems allow for speakers to be daisy chained together. In a typical system with one zone of audio, run a stereo or 4 conductor speaker wire from the amplifier to the closest speaker. Designate the first speaker as either left or right and connect the appropriate positive and negative wires to the speaker terminals.
Specifications Model: LS12T SUB Model: LS15T SUB Woofer: 12” (305mm) polypropylene cone with a Santoprene rubber surround Woofer: 15” (381mm) polypropylene cone with a Santoprene rubber surround Frequency Response: 22Hz – 100Hz ±3dB Frequency Response: 20Hz – 100Hz ±3dB Transformer Taps: 70V 300W, 150W, 75W 100V 300W, 150W 8 Ohms Transformer Taps: 70V 300W, 150W, 75W 100V 300W, 150W 8 Ohms Enclosure Material: Low density polyethylene (LDPE) non-corrosive sealed enclosure.
LIMITED FIVE (5) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (“Product”), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.
