D8 SUBWOOFER INSTRUCTION MANUAL
TABLE OF CONTENTS Safety 2 Design and Features 3 Features 3 Box Contents 3 Subwoofer Placement 3 Installing the Subwoofer Flush to a Wall or Cabinet 3 Subwoofer Bottom Amp Plate 3 Subwoofer Connections 4 Audio Connections 4 Connection Examples 4 Subwoofer Adjustments 6 SonARC 6 Specifications 7 Warranty 8 1
n IMPORTANT SAFETY INFORMATION 10. Power Sources — The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the unit. IMPORTANT: READ ALL OF THESE INSTRUCTIONS BEFORE YOU INSTALL OR OPERATE YOUR SUBWOOFER AND SAVE THESE INSTRUCTIONS FOR LATER USE. 11. Accessories and Attachments — Only use accessories and attachments specified by the manufacturer. 1.
Design and Features Your subwoofer’s location relative to walls will influence the amount of bass it produces — placing the subwoofer next to a wall will increase bass output; placing it in a corner will maximize its bass output. However, corner placement can increase standing waves in the room (peaks and dips in bass response related to the room’s dimensions) that can make the subwoofer’s bass performance sound uneven at different listening locations.
Subwoofer Connections Connection Examples Power Connection Your Sonance Cabinet D8 Subwoofer features a removable IEC power connector for 115V (see Figure 2). Plug the female end of the power cord into the power cord connector on the subwoofer’s rear panel and plug the male end into a grounded wall socket. Do NOT plug the subwoofer’s power cord into a convenience outlet on any other audio or video component. Follow the connection example that best describes your audio system.
Option 3 Integrated amplifier with left and right line-level outputs but no main in or amp in jacks (see Figure 5): Option 5 Wireless connectivity using the Sonance Wireless Transmitter (see Figure 7): VOLUME VOLUME REF REF WIRELESS INPUT STATUS MIN WIRELESS SYNC WIRELESS INPUT MAIN OUTPUTS AUDIO CABLE WIRELESS SYNC WIRELESS STATUS CROSSOVER WIRELESS STATUS LINE LEVEL INPUT STATUS 150HZ WIRELESS SYNC R 90 DEG CAUTION REPLACE FUSE ONLY WITH SAME TYPE AND RATING OFF ISOLATED AC 100-12
Subwoofer Adjustments Phase Adjustments When the subwoofer’s PHASE switch is in the 0 position, a positive input voltage will cause the woofer cone to move out (towards the room). When the PHASE switch is in the 180 position, a positive input voltage will cause the woofer cone to move in (away from the room) (see Figure 9). SonARC For Subwoofers Every Sonance Subwoofer comes with SonARC built in.
Specifications Model: D8 SKU: Black 93359, White 93374 Unit of Measure: Each Woofer: Two 8” (203mm) ultra long throw, glass fiber cone, rubber surround Frequency Response: 32Hz - 250Hz ±3dB Enclosure Material: Extruded aluminum with a matte black finish Power Output: 300 watts RMS (600 watts peak) Inputs: Line-level, speaker-level and low latency wireless Controls: Crossover, phase and bypass DSP: App controlled Sonarc automatic Dimensions with Feet: (W x H x D) 7 1/2” x 8” x 9” (191mm
LIMITED FIVE (5) YEAR WARRANTY Sonance warrants to the first end-user purchaser that this Sonance-brand product (product), when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense during the warranty period, either repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.