User's Manual
2
1
-
- Power: 3V lithium battery, CR 2450 type
o o o o
- Operating temperature: +5 C/41 F to +40 C/104 F
- Range: Up to 65 Ft.
- Fits into standard Decora Wall Plates
Commands are transmitted by radio waves at 433.42 MHz.
Operating Instructions
DECOFLEX RTS SWITCH
DESCRIPTION
PROGRAMMING
The DecoFlex RTS Switch is a wireless radio transmitter compatible with
all Somfy RTS Motors and externally mounted RTS receivers.
This is a low voltage device which does not need to be mounted inside an
electrical box. It can be mounted adjacent to an existing Decora style light
switch or as a stand alone device using the specific SOMFY low voltage
bracket (included).
White: 1810813
Ivory: 1810814
Black: 1810830
A. ADDING A DECOFLEX RTS WALL SWITCH - INITIAL INSTALLATION
IMPORTANT: for initial programming provide power only to the motor or receiver being programmed
1. Set the RTS Receiver or Motor into its Programming Mode (Refer to the installation instructions of the relevant
RTS receiver or motor for this procedure).
2. Select the Channel to be memorized by pressing the appropriate button. The button will light. Refer to Figure 1.
3. Using a paperclip or similar device, briefly press the programming button (1 sec max) located on the DecoFlex Switch
4. The receiver/motor will confirm the addition of the new DecoFlex Switch in their respective manners.
FIGURE 1
C. REMOVING A DECOFLEX RTS SWITCH FROM THE MOTOR OR RECEIVER’S MEMORY
1. Place the receiver or motor into programming mode by pressing and holding the programming button (for 3 sec.) of a DecoFlex RTS Switch or Telis
Transmitter that has been previously memorized. It should NOT be the one to be removed from memory.
2. The receiver/motor will confirm PROGRAMMING MODE in their respective manners.
3. Select the RTS Switch or Channel to be removed from memory. Press the programming button (1 sec. max.) on the RTS switch.
4. The receiver/motor will confirm the removal of the RTS Switch or Channel in their respective manners.
Ref. No. 2501819
SOMFY SYSTEMS, INC. 3/08
C
SOMFY SYSTEMS, INC.
47 Commerce Drive
Cranbury, NJ 08512
SOMFY CANADA
6315 Shawson Drive, Unit #1
Mississauga, Ontario L5T1J2
SOMFY SYSTEMS, INC. reserves the right to change,
update or improve this document without prior notice.
B. ADDING MULTIPLE DECOFLEX WALL SWITCHES
1. Place the receiver or motor into programming mode by pressing and holding the programming button (for 3 sec.) of a
DecoFlex switch or Telis Transmitter that has been previously memorized. There is no need to access the external receiver
for this operation.
2. The receiver/motor will confirm PROGRAMMING MODE in their respective manners.
3. Select the NEW channel or RTS Switch to be memorized. Press the programming button (1 sec. max.) on the DecoFlex RTS switch.
4. The receiver/motor will confirm the addition of the new RTS Switch or Channel in their respective manners.
Programming
Button
Select the
Channel
3
OPERATION
1. Select the channel of the window treatment to be operated by pressing the appropriate button. The button will light.
Refer to Figure 2.
2. To raise the window treatment, press the UP button. Similarly, to lower the window treatment, press the DOWN button.
3. To stop the window treatment at any time, simply press the STOP button.
FIGURE 2
Select the
Channel
STOP
Button
UP
Button
DOWN
Button