Users Manual Package contents. Please check the items in the package, if there is any short or damage in the package, please contact your local representative immediately.
Users Manual Exterior introduction WLAN Status light GPRS Status light SIM card connector slot 04
Users Manual GPRS Status light GPRS Status light indicates the connection status when it is powered on.
Users Manual To switch in between GPRS and WLAN There is a switch on the bottom side of the USB GPRS/WLAN dongle. GPRS is enabled when switched to G and WLAN is enabled when switched to W. You may observe the status by the indicate light on the front panel, upper 7 color LED is for GPRS and the lower single color LED is for WLAN. WLAN is enabled when switched to (W) 07 GPRS is enabled when switched to (G) Note: USB GPRS/WLAN dongle's factory setting is set to (G).
GPRS modem Installation & setting procedures 07
Users Manual System requirements Please make sure your computer's hardware and software meet the following requirements, please refer to your computer's users manual or contact your local representative for more information. Software & hardware requirements A valid SIM card (GPRS service is granted) An USB port or a PCMCIA to USB converter card is available.
SIM card installation Insert the SIM card Insert the SIM card into the SIM card compartment with the chamfered corner to click into the housing. Chamfered corner Note: 1. Please make sure the chamfered corner on the SIM card matche with the latch on the housing. 2. If the SIM card is inserted into the housing with incorrectly direction, the SIM card won't be able to click into the chamfered latch.
Users Manual Remove the SIM card Gently pressing the chamfered latch on the housing, the SIM card will be ejected from the housing automatically.
Install the GPRS/WLAN Dongle on the PC Please follow the following procedures to install the driver software. The Installation Wizard will automatically determine the type of operating system on your computer and choose the proper driver for the GPRS/WLAN Dongle. When the software installation is completed, plug the GPRS/WLAN Dongle into the USB port on your computer; the operatingsystem will automatically identify the GPRS/WLAN Dongle. Then you may configure the software settings, please refer to page 37.
Users Manual Install the software Install the GPRS/WLAN Dongle driver software 1. Click on "install software". 2. Install the software window. Click on left button. 1 install driver 2 install Adobe Acrobat Reader 3 exit.