User Manual

1. Insert the WLAN Dongle into the
USB port on the computer, computer
will show found new hardware and
the "Upgrade Device Driver Wizard"
will show up, choose "search for a
suitable driver" and then click on
"Next" to continue.
4. When the installation is
completed, "WLAN Monitor" shortcut
icon will be on the desktop.
5. Site Survey: Click on Rescan to
search the nearby AP (access point),
the names of the AP and their signal
strength will be displayed. Double
click on the AP you wished to access
to start the connection. You may
also choose to save the profile of the
AP to be used in later days.
6. Security: You may choose WEP
or TKIP for security; WEP can
choose 64 or 128 Bit encryption.
2. Put the installation CD into the
CDROM drive and the installation
program will get invoked.
3. Click on install driver to proceed.
Easy installation Guide:
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiated radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device complies RF exposure limits of OET 65C