SKYWAY-MOBILE SERIES Subscriber Station User’s Guide July 2008 Rev 1
1. Declaration Note: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Fig 2-1: CPE appearance Fig 2-2: CPE detailed views Items Dimensions Weight Description 150mm×95mm×40mm About 105g (excluding the battery) Power Adapter Input 120V AC input, 5V DC 2A output Power Consumption 3W Atmospheric pressure 86kPa ~ 106kPa Operating temperature 0C ~ +45C Storage temperature -25C ~+55C Ambient humidity 20%~75% Table 2-1 CPE technical parameters 3.
may start the CPE installation using the subsequent illustrations contained in this user’s manual. In the event of any difficulty during installation, please feel free to contact your CPE provider. CPE installation Make sure your CPE is off before the installation, and the installation steps are as follows: 1. Rotate the antenna 180 degrees clockwise, and fix the antenna by adjusting the antenna lock nut. Caution: Don’t overexert the antenna itself while rotate it.
4. Troubleshooting If your CPE can’t access Internet after the installation, please observe the indicator light of your CPE. Indicator light The indicator lights indicate important information during the use as shown in Table 4-1. Status of major operating parameters, including the wireless signal, network connection and power problems could be detected by those lights.
Weak or no signal for a long time Signal coverage is poor. The computer indicates that it doesn’t connect to the internet. Something is wrong with the connection of the Ethernet line. The signal is normal and the computer indicates that it connects to the Internet, but actually can’t surf the internet. Slow speed The network settings are not correct. Pick up the phone, but there isn’t any dial tone. Something is wrong with the connection of the phone line.
6. Notes Operating environment Forbid using CPE in weather conditions prone to thunder and lightening and always pull out the power adapter in such situations. Do not use CPE at refueling points and do not use CPE near fuel or chemicals either. Cooling is needed when the CPE is running, maintain operating temperatures of +5C to +40C and do not put the CPE and the power accessories at dusty places. Don’t seal off the CPE or put other things on the CPE.