TABLE OF CONTENTS Product Registration 1 Important Safety Instructions 2 Important Electrical Information/Grounding Instructions 3 Important Operation/Precaution Instructions 4 Important safety/Safeguard Instructions 5 Control Instructions 7 General Maintenance 8 Diagnosis Guide 9 FCC Warning 10 Error Messsage 11 Manufacturer’s Limited Warranty 12 WARNING: This product can expose you to chemicals including Toluene and Acrylamide which are known to the State of California to cause Cancer and birth def
Before returning your Sole product to any retailer, or if you require any assistance with assembly or technical support please call us first for assistance at 866-697-6531. Thank you for your Sole purchase.
CONGRATULATIONS ON YOUR NEW SRVO AND WELCOME TO THE SOLE FAMILY! Thank you for your purchase of this quality product from SOLE. Your new SRVO has been manufactured by one of the leading fitness manufacturers in the world and is backed by one of the most comprehensive warranties available. SOLE will do all we can to make your ownership experience as pleasant as possible for many years to come. If you have any questions about your new product contact SOLE Fitness at 866-780-SOLE (7653).
IMPORTANT SAFETY INSTRUCTIONS WARNING - Read all instructions before using this appliance. DANGER - To reduce the risk of electric shock disconnect your SRVO from the electrical outlet prior to cleaning and/or service work. WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons, install the treadmill on a flat level surface with access to a 120-volt, 15-amp grounded outlet with only the treadmill plugged into the circuit.
IMPORTANT ELECTRICAL INSTRUCTIONS WARNING! Route the power cord away from any moving part of the SRVO including transport wheels. NEVER remove any cover without first disconnecting AC power. If voltage varies by ten percent (10%) or more, the performance of your SRVO may be affected. Such conditions are not covered under your warranty. If you suspect the voltage is low, contact your local power company or a licensed electrician for proper testing. NEVER expose SRVO to rain or moisture.
a properly grounded outlet, (shown below) can be installed by a qualified electrician. The green colored rigid earlug, or the like, extending from the adapter, must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
IMPORTANT OPERATION INSTRUCTIONS NEVER operate SRVO without reading and completely understanding the results of any operational change you request from the computer. NEVER use your SRVO during an electrical storm. Surges may occur in your household power supply that could damage SRVO components. Unplug SRVO during an electrical storm as a precaution. Use caution while participating in other activities while using your SRVO; such as watching television, reading, etc.
Read the owner’s manual in its entirety before operating the Strength Equipment. Failure to obey this warning can result in injury or death. SOLE FITNESS® and the SOLE Fitness logo are registered trademarks of Dyaco International. IMPORTANT SAFETY INSTRUCTIONS This chapter includes precautions and fitness safeguards for the installation and use of the manufactured by SOLE. Please read this chapter carefully before installing or using your strength equipment.
DO NOT ATTEMPT TO USE OR REPAIR ANY ACCESSORY APPROVED FOR USE WITH THE SOLE FITNESS EQUIPMENT WHICH APPEARS TO BE DAMAGED OR WORN. Check regularly and follow all instructions for maintenance as specified in this manual. Replace immediately any defective parts and do not operate unit until all repairs are complete. Operating Warnings Keep children away from the equipment.
Control Instructions 1. Resistance adjustment On the SRVO control panel, you can perform resistance adjustments, switch modes, and start/stop operation. If the number on the display is flashing, SRVO is in adjustable state. You can adjust the resistance weight by turning the knob. Turn to the right to increase, and turn to the left to decrease. After adjusting to the desired weight, press the start and stop button to engage resistance.
4. Switch mode There are three resistance modes for SRVO, Standard mode, Eccentric mode, and Isokinetic Mode. Press and hold Start/Stop button for three seconds, then turn the knob to switch between mode. Mode Mode 1 Description ● Constant resistance(isotonic) through out range of motion Standard ● Eccentric mode means that the resistance is greater when the cable is retracting, and the resistance is less when the cable is pulled up.
DIAGNOSIS GUIDE 1. Wireless switch unresponsive. Make sure battery is installed correctly. If blue and red light are flashing at the same time, that means battery was not installed properly. If only blue light is showing, that means battery was installed correctly and ready to pair SRVO and wireless switch again. 2. No resistance on cable Switch to mode 3 isokinetic mode. Pull cable all the way out, slowly release the cable. Restart the machine after cable is retracted all the way. 3.
FCC WARNING: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
ERROR MESSAGES Error Code Error message Probable cause Suggested action 0x40 Power module low voltage Defective power module/ Utility power low voltage Restart machine. Replace module if issue not resolved. 0x80 FO control error Power module defective/low voltage/ or short circuit Turn off machine 0x100 Power module high temperature Power module overload Turn off machine to cool down 0x400 High voltage Voltage too high for control module Turn off machine, check bleeder resistor.
MANUFACTURER’S WARRANTY LIMITED SRVO WARRANTY Effective February 1, 2021 SOLE warrants all its treadmills’ parts, for a period of time listed below, from the date of retail sale, as determined by sale receipt, or in the absence of a receipt eighteen (18) months from the original factory shipping date. SOLE’ s responsibilities include providing new or remanufactured parts, at SOLE’ s option, and technical support to our independent dealers and servicing organizations.
P.O. Box 2037 Jonesboro, AR 72402-2037 Product features or specifications as described or illustrated are subject to change without notice. All warranties are made by SOLE.
Before returning your Sole product to any retailer, or if you require any assistance with assembly or technical support please call us first for assistance at 866-697-6531. Thank you for your Sole purchase.