Operations Manual
COVER DEPLOYMENT COVER REMOVAL
1) Grasp the CLOAK door in your right hand with thumb finding the left 1) Pull the cover up and over the passenger side mirror and front left bumper,
indentation in the system door. Rotate your wrist to the right and the door
making sure the cover has cleared the mirror. (Fig. 1)
will pop open. (Fig. 1)
2
)
Facin
g
the front of the vehicle,
g
ras
p
the s
y
stem handle in
y
our ri
g
ht hand an
d
2
)
Gras
p
the s
y
stem handle in
y
our ri
g
ht hand and ad
j
ust so the handle
twist to the right to remove it from the front clip. (Fig. 2)
control buttons are directly under your thumb. (Fig. 2)
Fig. 1 Fig. 2 Fig. 1 Fig. 2
3) To begin cover deployment, press the OUT button and hold. The cover will 3) Keep the handle low as you back slightly away towards the bumper on the
continue to move as long as the button is depressed. (Fig. 3) driver's side, ensuring the elastic hem clears from under the bumper. (Fig. 3)
4) Hold the button for approximately five seconds, then begin to walk to the 4) Make sure the cover clears the driver's side mirror, then, walk the cover
front of the vehicle while holding the handle high over the center and top of the towards the rear of the vehicle. About midway to the rear, press the IN
vehicle. The objective is to deploy the cover with gentle tension so that it stays
button. (Fig. 4)
on the top and center of the vehicle. This is achieved by walking slightly faster
than the system presents the cover. Avoid excessive tension. (Fig. 4)
Fig. 3 Fig. 4 Fig. 3 Fig. 4
5) When you reach the front of the vehicle, and you judge the cover is 5) Accelerate your pace so you are directly behind the vehicle when there
sufficiently deployed, release the OUT button. Grasp the barrel of the handle
is still about six feet of cover outside the cover's container. (Fig. 5)
with your left hand, grab a handful of the cover just above the narrow trace with
6) Now, grab the trace and gently, but firmly, pull, stretching the elastic hem as
your right hand, and gently stretch the cover's elastic so you can snap the the rest of the cover is retracted. This helps eliminate any air that may be
handle barrel into the front bumper clip with your left hand. (Fig. 5) trapped. (Fig. 6)
6) Now, stretch the left hem of the cover over the passenger side mirror and
then down over the bumper. Repeat this process on the driver's side. (Fig. 6)
Fig. 5 Fig. 6 Fig. 5 Fig. 6
7) Walk to the back of the vehicle and gently pull the cover enough to tuck the 7) Stop pressing the button when there is about a foot of trace left. Place the tip
elastic under each side of the bumper. (Fig. 7)
of the barrel into the right side of the retaining clip. Press forward until there is
8) Close the system door by locating the left indentation on the door and enough clearance to dock the rear of the handle. (Fig. 7)
rotate your wrist to the left. You will hear the latch click. (Fig. 8) 8) Close the system door by locating the left indentation on the door and
the left. You will hear the latch click.
Fig. 7 Fig. 8 Fig. 7 Fig. 8
Insert Photo
No. 1 Here
Insert Photo
No. 2 Here
Insert Photo
No. 3 Here
Insert Photo
No. 4 Here
Insert Photo
No. 9 Here
Insert Photo
No. 5 Here
Insert Photo
No. 6 Here
Insert Photo
No. 7 Here
Insert Photo
No. 8 Here
Insert Photo
No. 11 Here
Insert Photo
No. 10 Here
Insert Photo
No. 12 Here
Insert Photo
No. 13 Here
Insert Photo
No. 14 Here
Insert Photo
No. 15 Here
Insert Photo
No. 16 Here