SMRTGrid Operator’s Manual Operator’s Manual for SMRTGrid Line Beacon Dave Martin SMRTGrid © 2019 SMRTGrid Inc.
SMRTGrid Beacon 1|Page SMRTGrid | 1675 Samco Road | Rapid City, SD 57701 SMRTGrid Doc No: 140-100101 REV 0
CONTENTS Getting Started .................................................................................................................................................. 3 Safety Notice ................................................................................................................................................. 3 Necessary Inspection .....................................................................................................................................
GETTING STARTED Safety Notice SMRTGrid beacons should be serviced and installed by Authorized personnel only. Under no circumstances attempt to dismantle, open, or tamper with SMRTGrid beacon. COPYRIGHT SMRTGrid reserves the right to modify or change part of or all the specifications and pricing policies at company’s sole discretion. Information in this publication replaces all previous corresponding material. NOTE: SMRTGrid and the SMRTGRID logo are registered trademarks of SMRTGrid Inc.
TECHNICAL INFORMATION Criteria Values Power • • • • • • • • • • 3 Ni-MH cells Rechargeable via solar panel Min. 72+ hrs. of operation with no sunlight Verizon LTE LTE Cat M1 Link to server/cloud 802.15.4 Bluetooth LoRa Module 7+ Years • • • • • Gyroscope Accelerometer Magnetometer -20°C to 85°C Humidity levels up to 95% Processor Memory • • • ARM 256+ Mb Quad-SPI Flash 1+ SDIO Card FCC • Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules.
SERIAL NUMBER LOCATION Individual SMRTGrid serial numbers are located on the lower left portion of the identifying label.
UNPACKING Carefully unpack the mailer box and confirm following parts are included: that the 1. SMRTGrid Beacon 2.
SMRT GRID COMPONENTS 1 5 2 4 1. Solar Panel 2. Identification Label 3. External Power Interface Connector 7|Page 3 4. Mounting Bracket 5.
INSTALLING BEACON • • • • Align bracket tabs perpendicular to utility pole Fold mounting tab until flush with pole Hammer lag bolts through beacon bracket Repeat for opposite side 1|Page SMRTGrid | 1675 Samco Road | Rapid City, SD 57701 SMRTGrid Doc No: 140-100101 REV 0
POWERING ON YOUR DEVICE 1. At install, unit is powered on using the activation dongle on the power connector. The dongle is installed by aligning the pins and then screwing the dongle onto the connector. The beacon should then power on. 2. Verify the unit registers on the SMRTView web site with a data report that matches the serial number on unit.
TROUBLESHOOTING For troubleshooting information, reference guide provided on www.SMRTGrid.com or contact SMRTGrid representative for further inquiries. CONTACT US If you have any problems or questions when installing or using SMRTGrid beacon, please contact SMRTGrid by visiting: www.SMRTGrid.com In case of damaged or defective SMRTGrid beacon, request an RMA by visiting: www.SMRTGrid.