User Manual

Connection Tutorial

Connection steps:

1. Download "YI loT" APP on your phone

2. Click on the "add button" in the upper right corner of the App home page interface,

select the camera of the corresponding model, connect camera to power supply at

the same time. After hearing the voice prompt of the camera, tap "heard voice

prompt" to enter the WIFI connection interface. After entering the password, the

mobile phone side will generate QR code.

3. When the camera prompts 'dididi', please use the camera lens to scan the QR code.

Possible problems during connection and solutions:

A) The camera prompts to wait for the connection, but there was no response after

scanning the QR code.

1. Check the name of WIFI (don't be too long and complicated, without Chinese and

special symbols).

2. Make sure the scanning distance is appropriate, and the speed of scanning should

not be too fast and do not move frequently.

3. Click on the QR code picture to enlarge the QR code, and then scan.

B) The camera scans the QR code and indicates that the QR code is invalid

1. Check the bound camera model is correct or not

C) Camera prompt "wifi connection failed"

1. Verify that the WIFI name and password are entered correctly

2. Try to restart the router before connecting

PAGE 1
Connection Tutorial Connection steps: 1. Download "YI loT" APP on your phone 2. Click on the "add button" in the upper right corner of the App home page interface, select the camera of the corresponding model, connect camera to power supply at the same time. After hearing the voice prompt of the camera, tap "heard voice prompt" to enter the WIFI connection interface. After entering the password, the mobile phone side will generate QR code. 3.
PAGE 2
3. Check whether the router has set up mac filtering 4. Check the router blacklist D) The WIFI password entered is correct but still prompts for an error 1. The camera only supports 2.4G band, and you need to make sure that the WIFI connected is not 5G band. 2. Restart the router 3. Switch the router encryption mode to WPA/WPA2 mode 4. Open the QOS in the advanced settings and then set the level to the highest 5. Check whether the router has set up mac filtering 6.