User's Manual

ManualsBrandsSMK ManualsElectronicsBluetooth Module

User Manual

5-5 Togoshi 6 Chome, Shinagawa-Ku, Tokyo 142-8511 Japan

Bluetooth

module with a built-in 2.4GHz band antenna

Model Name: Bluetooth Module

Model number: BT401

GENERAL

BT401 is a Bluetooth communication module complying with Bluetooth Version 3.0. It

operates in the two modes, Command Mode and Automatic Mode, and makes automatic

connection in Automatic Mode. It supports master and slave operations. It becomes an

adapter which transfers various data wirelessly between master and slave devices.

Therefore, wireless data communication can be realized by only replacing the cable

between apparatuses with BT401, without changing a host system.

Features

1) Surface mounting module with a built-in antenna.

2) Unique automatic connection method and command connection mode can be

selected as control methods.

3) Support various profiles and protocols at user's requests.

Integration to the end product

The SMK Transceiver Module, model BT401 has to be installed and used in accordance

with the technical description/installation instructions provided by the manufacturer.

The system may only be implemented in the configuration that was authorized. Note that

any changes or modifications to this equipment not expressly approved by the

manufacturer could void the user’s authority to operate this equipment.

Specification

1) Bluetooth® Specifications Ver.3.0-compliant

(The high speed option is not supported.)

2) Frequency Range: 2402-2480 MHz

3) Modulation System: GFSK, π/4－DQPSK, 8-DPSK

4) Max. Data rate: 3Mbps

5) Antenna: PCB (Monopole) type

Summary of content (4 pages)

PAGE 1
User Manual Bluetooth® module with a built-in 2.4GHz band antenna Model Name: Bluetooth Module Model number: BT401 GENERAL BT401 is a Bluetooth communication module complying with Bluetooth Version 3.0. It operates in the two modes, Command Mode and Automatic Mode, and makes automatic connection in Automatic Mode. It supports master and slave operations. It becomes an adapter which transfers various data wirelessly between master and slave devices.
PAGE 2
User Manual Regulatory Information USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy.
PAGE 3
User Manual when the module is installed into the system, “Contains FCC ID:GT3FC018” shall be placed on the outside of final host system. Caution: Exposure to Radio Frequency Radiation. (1) When use in mobile devices This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE).
PAGE 4
User Manual 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjunction with any other antenna or transmitter. Instructions to OEM Integrators A User manual provided to the end user must indicate the operating requirements and conditions that must be observed to ensure compliance with the above-mentioned FCC /IC RF Exposure guideline.