User's Manual

2
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
Batteries or batteries installed apparatus shall
not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION
The use of optical instruments with this product
will increase eye hazard. As the laser beam used
in this INTERNET TV BOX is harmful to eyes,
do not attempt to disassemble the cabinet. Refer
servicing to qualified personnel only.
This label is located on the laser protective
housing inside the enclosure.
This symbol is intended to alert
the user to the presence of
uninsulated “dangerous volta
ge”
within the product’s enclosure that
may be of sufficient magnitude to
constitute a risk of electric shock to persons.
This symbol is intended to alert
the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
These graphical symbols are located on the AC
adaptor.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet
on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
Precautions
• To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on
the apparatus.
• The set is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the set
itself has been turned off.
• Install this unit so that the AC power cord can
be unplugged from the wall socket
immediately in the event of trouble.
• The nameplate is located on the bottom of the
unit.
Installing
• Do not install this equipment in a confined
space, such as a bookshelf or similar unit.
FCC WARNING
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
The shielded Interface cable (LAN cable) must
be used with the equipment in order to comply
with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
FCC Radiation Exposure
Statement:
This equipment complies with FCC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65. This equipment should be installed and
operated with at least 20 cm and more between
the radiator and person's body (excluding
extremities: hands, wrists, feet and ankles).
IC Radiation Exposure
Statement:
This equipment complies with IC radiation
exposure limits set forth for uncontrolled
equipment and meets RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment
has very low levels of RF energy that it deemed
to comply without maximum permissive
exposure evaluation (MPE). But it is desirable
that it should be installed and operated with at
least 20 cm and more between the radiator and
person's body (excluding extremities: hands,
wrists, feet and ankles).
When using the unit, use indoors.
Contains FCC ID : AK8NSZGT1
Contains IC : 4250A-DWMW034
This class B digital apparatus complies with
Canadian ICES-003.
Owner's Record
The model and serial numbers are located at the
rear of the unit. Record the serial number in the
space provided below. Refer to them whenever
you call upon your Sony dealer regarding this
product.
Model No.______________
Serial No.______________
For Customers in the USA
If this product is not working properly, please
call 1-866-909-7669.
For Customers in Canada
If this product is not working properly, please
call 1-877-602-2008 for Peace of Mind
Warranty Replacement service.
For other product related questions please
contact our Customer Information Service
Center at 1-877-899-7669 or write to us at:
Customer Information Service 115 Gordon
Baker Road, Toronto, Ontario, M2H 3R6
WARNING
Operation is subject to the following two
conditions;
(1) this device may not cause interference,
and
(2) this device must accept any interference
received,
including interference that may cause
undesired operation of the device.
Note：Description inside red frames is no related to
this equipment RXT1000-0801E.